Wood flooring has made a comeback in the past few years and is once again the floor of choice for many builders. When we think of wood paneling, most think of Grandma's basement, or a rec room we played in as kids. While it is typically used as wall covering, it can be used with great effect on floors as well. With paneling you can do it quicker and cheaper with surprisingly good results.
Types of Paneling
Beadboard or grooved wooden paneling can give the look of traditional board flooring. It comes in a wide selection of wood varieties from pine to hardwoods. Choose the thicker varieties for more durability. Unfinished panels are best because wall finishes are not typically durable enough. You can stain or paint them after installation
Luanne is typically a mahogany-grained plywood used for cabinet panels, soffits under the eaves of houses and the like. Laid on solid surfaces, such as concrete or wood floors, it can work well if provided with adequate finish. It comes in 1/4-inch thick sheets that make it light and easy to work with.
Cabinet grade hardwood plywood is slightly more expensive than the plywood typically used for dog houses and similar structures. It comes in a variety of grains. Patterns, such as vertical grooves, can be cut into its surface to simulate wood board flooring, or install the plywood "as is" for a modern feel.
Floor Design Ideas
Use panels with grooves and cut “dove tail” style notches into each end of the panel. Every other “board” is shortened with the next panel in line being cut opposite to fit into it. This gives the appearance of traditional board flooring.
Cut hardwood plywood or luanne into large squares. Sixteen-inch squares fit three across and six down on a standard 4 x 8 foot sheet of plywood. Lay them with the grain running in opposite directions to create a checkerboard type “parquet” effect.
Cut a roundover detail on the edge of large plywood panels and lay them full size for an open modern feel. Use wood-colored caulk to seal any gaps between panels and apply your finish after the floor is installed.
Finishing Your Floor
Wood panels can be stained with oil- or water-based stains. Separate stain and finish is best for floors. Choose a stain that complements existing woodwork. Colored stains, such as red, green or blue, are even available that allow the grain to show through for a beautiful effect.
Painted finishes can be used on wood floors. Distress paint finish with a sander and add clear varnish on top for a “shabby chic” look. Or go with a high gloss for modern elegance. Choose paints with an outdoor rating for best durability. Floor paints are the best.
Clear polyurethane or floor wax can be applied over stain or paint or directly on unfinished wood for a natural look. Choose products recommended for floors because others can be slippery. In waxes, choose a wax with a high percentage of solids.
- Photo Credit Jupiterimages/Photos.com/Getty Images
How to Use Wall Paneling for Flooring
Wall paneling comes in a wide variety of lengths, types of wood and colors. While traditionally people have used it only on...
How to Mix Wood Floors & Walls
Many homeowners are curious about how to bring together several types of wood finishes in one room. A modern den may have...
What Kind of Flooring Goes With Paneling?
Natural wood paneling, synthetic paneling and painted paneling are common wall treatments in home design. Due to its plank-like qualities and striped...
Ideas for Flooring with Wood Walls
Decisions for flooring should be carefully considered. For instance, if your floor has to stand up to a lot of wear and...
Problems With Paneling Buckling
Paneling is used to cover a wood-framed structure of a home or building. It's usually made of plywood or a similar-grade wood....
What Floors Look Best With Wood Paneling?
Wood paneling comes in a variety of styles and textures to enhance a room's appearance. It's now featured in raised, panel wainscoting...