What Screws to Use With Cement Boards?

Save

Cement board backers are commonly used to cover walls, ceilings and floors over which another type of material will be installed, such as tile or poured cement. The boards create a barrier between the frame or exterior of the area and the new floor, and therefore must be strongly attached in place to prevent shifting or damage later.

Cement Board Screws

  • To attach cement boards to your fixtures, you must use screws designed specifically for cement board installation. Many cement board manufacturers provide or offer these screws with your purchase; you can also find them at hardware and home improvement retailers. The screws are finished with a special coating that allows them to resist corrosion, which can occur thanks to the alkali levels in the cement of the boards. They also feature small grooves directly under the screw head to allow them to dig into the cement board for better hold.

Nail Options

  • If you cannot find or do not have access to cement board screws, there are some types of nails you can use for installing the cement boards. If nails are the way you choose to go, use only galvanized or hot-dipped nails. These types of nails, also used in outdoor decking and roofing installations, have a similar corrosion-resistant coating that allows them to resist rusting or fading from moisture exposure --- or, in this case, from the alkali state of the cement board.

Installing

  • Install a fastener every 6 to 8 inches along the perimeter of the boards. In terms of cement board screws, the size of the screw you need will vary depending on the fixture or base to which you attach the board. Cement board attached to plywood or similar underlayment will hold with only 1 1/4-inch screws; for thick or heavy metal fixtures, use 1 5/8-inch screws. In general, 1 1/2-inch galvanized nails will hold the board firmly in place. For flooring or wall installation, some builders choose to apply a thin layer of thinset mortar under the cement board to prevent any shifting or expansion. Even if you use this extra adhesive, you should still apply the nails or screws.

What to Avoid

  • While cement board may look and feel a lot like drywall or Sheetrock, the makeup of the interior of the boards is completely different. Therefore, drywall screws or nails will not work for cement boards. The fasteners designed for use with drywall do not feature the corrosion- and alkali-resistant coating that enables the cement board or galvanized fasteners to last.

References

Promoted By Zergnet

Comments

You May Also Like

  • How to Screw Into Concrete

    How to Screw Into Concrete. Setting a screw in concrete takes special tools and some talent. With the right information and the...

  • How to Install Hardiebacker Board

    If you’re preparing to do a ceramic floor or wall installation, it’s recommended that you install HardieBacker cement board on your subfloor...

  • How to Nail Cement Board Siding

    Installing cement board siding can add greatly to the look of your home. It's a strong, durable material that has the look...

  • Directions to Install Durock

    Durock cement board creates a stable masonry surface for installing tile and natural stone on floors and walls. Durock boards are two-sided....

  • How to Secure a Hardie Board

    Hardie board is a type of fiber cement board that is used for many different applications. It is commonly used as an...

  • Differences Between Wallboard, Drywall and Cement Board

    Contemporary specialized construction materials greatly reduce the time and the skilled labor necessary to complete projects once entrusted to craftsmen. Sheet-type materials...

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!