Chainsaw engines require a premixed fuel to keep them running at the proper temperatures. The oil that's added to the fuel lubricates the piston and crankshaft, but it also keeps the engine cool enough to keep running. Without this oil in the gasoline, the piston will seize and the engine will be ruined.
Engine Heats Up
With the regular mixed fuel, the oil keeps the piston lubricated inside the cylinder. The piston moves up and down at incredibly high rates of speed. The crankshaft also turns at these same speeds. This high rate of speed causes enormous friction to build and heat up these engine parts. The oil, however, keeps these parts just cool enough to keep running. If no oil is present in the gas, the fuel will still ignite and power the piston and crankcase. However, the fuel will burn at higher temperatures, resulting in piston failure.
Without the oil to keep the fuel from burning at a high temperature, the piston will seize up. The metal on the cylinder and the piston will heat and expand to the point where the piston no longer fluidly moves up and down inside the cylinder. This will cause friction inside the cylinder, eventually causing the piston to freeze up or stop moving completely. This will also cause the crankcase to stop turning underneath the piston. When the crankcase stops moving, all other systems shut down instantly.
Most often, if straight gas is burned inside the engine, the engine is ruined. Little, if nothing, can be done to fix this error. The seized piston can't move, and the crankcase can't turn. While the piston and cylinder may be able to be removed and replaced, it is usually unlikely, as the metal will have heated up and burned out all other parts within the piston and crankcase. These systems are difficult to reach and costly to fix. Often, a new chainsaw will cost less than trying to fix the seized piston, which may not even guarantee it will work again.
Correcting the Problem
If you've put straight gas in the fuel tank, don't start the engine. If straight gas is used, it can damage and ruin the piston and crankcase within a minute, as the gas doesn't take long to burn out these sensitive parts. Drain the tank immediately into a separate fuel container. Pour approximately 1 tsp. of clean water into the tank, swirl it around and dump it out. Change the fuel lines and, if possible, remove the carburetor and clean it to prevent any unmixed gas from entering the cylinder.
- Photo Credit Jupiterimages/Photos.com/Getty Images
Why Is My Stihl Chainsaw Hard to Start?
Stihl chainsaws, like most two-cycle gas engines, take only three things to operate: spark, compression and fuel. Hard or erratic starts are...
What Kind of Oil Do Electric Chain Saws Use?
Electric chain saws derive their power from an electric source, so they don't need fuel to run. Most gas chain saws require...
What Is 2 Cycle Engine Oil?
Perhaps 2-cycle engine oil catches your eye in the store. With all the formulas and weight of oil available, it can prove...
How to Prime a Carburetor
After thoroughly cleaning the fuel lines and carburetor of your vehicle you may find that you have cleaned it so well that...
How to Mix Gas and Oil for Chainsaw Fuel
How to Mix Gas and Oil for Chainsaw Fuel. Fueling a chainsaw is not quite as straightforward as putting gas in your...
Chainsaw Troubleshooting: Chain Stops While Cutting
The chainsaw can be one of the handiest power tools available. Whether people use them regularly or not, chainsaws frequently misbehave. Chains...
The Oil-to-Gas Ratio for the Craftsman 2.0 Chainsaw
The Craftsman 2.0 chainsaw, as with all gas-powered Craftsman saws, requires mixed fuel for combustion. This fuel combines gasoline and an engine...
Yellow Cake Recipe Using Vegetable Oil
Certain yellow cake recipes use vegetable oil as a primary ingredient. Find out about a yellow cake recipe that uses vegetable oil...
How to Mix Gas & Oil Chainsaw Fuels
Learn how to mix gas and oil to make fuel for your chainsaw in this free educational video.