The Purpose of a Plumbing P-Trap

Save

A P-trap is the most common of the traps found in a house's plumbing system. It's created by adding a 90-degree fitting to a U-bend in a piece of pipe. When attached correctly to a pipe's outlet side, it resembles a P shape. Also known as a sink trap, it's found under most sinks. It acts to create a water seal that prevents sewer gas from entering through plumbing drain pipes and into the house.

Fixtures

  • In accordance with national and state plumbing codes, P-traps have to be placed under just about every plumbing fixture, which includes sinks, bathtubs and toilets. These P-shaped bends trap a small amount of water at their bottoms. It's this water in the bend below each fixture that acts as a barrier to smells, gases, insects and bacteria. That way, they stay out of the interior of the home and away from residents.

Seals

  • As for P-traps, the depth of seal, which is the height of the water remaining in the trap, is important. Required depths run from 2 inches in older piping, which empties in to an open drain up to 3 inches for new plumbing that's enclosed. If your home's fairly new, chances are good that the depth of seal in your traps will be at least 3 inches.

Issues

  • Because P-traps are designed to be low points under a sink or other fixture, they can often become collection points for hair and other objects. Toothbrushes, jewelry, combs and other objects can end up trapped down within them, which can eventually lead to clogging of that particular fixture. Fortunately, most P-traps are designed to be easily disassembled so that they can be cleaned out without having to disconnect the fixture's entire plumbing setup.

Evaporation

  • If you don't use your sinks or bathtubs for several days, you may begin to notice sewer gas-like odors coming from them. That's because the water at the bottom of their P-traps has evaporated away. When that occurs, it's much easier for gases from your home's main drain pipes to enter. The solution to this problem is to install what are called trap primers. These replenish water in P-trap bottoms on a regular basis.

Related Searches

References

  • Photo Credit Jupiterimages/Photos.com/Getty Images
Promoted By Zergnet

Comments

Resources

You May Also Like

  • What Is a Plumbing Drum Trap?

    Plumbing traps have two basic functions: to keep sewer gases from entering a home and to catch heavy items not meant to...

  • How to Check Plumbing Vents

    The purpose of plumbing vents is not only to release sewer gases, but to allow air into the waste lines. When water...

  • How to Add a Clean-Out Trap to a Sewer Pipe

    Clean-out traps are very important components to a septic system. However, they were not always used in some of the older systems....

  • Types of Drain Traps

    Gases, insects and foul smells can't penetrate a waste line's drain trap. Drain traps are required by most local plumbing codes --...

  • Hooking Up a P-Trap to a Sink

    What is a P-trap used for in bathroom installation? Learn how to add a new bathroom to a home, including tips on...

  • Remedy for Trapped Gas in Chest Cavity

    Gas trapped in the chest area can be as alarming as it is painful. It isn't uncommon for chest gas pains to...

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!