Skyjack 3220 Specs


The Skyjack SJIII 3220 is a DC electric flat surface scissor lift working platform. It is most often used for repairs and remodeling in factories and warehouses. Rental agencies offer it to customers who use it to paint and repair high walls when restoring homes and other properties.

Skyjack was founded in 1986 and is based in Guelph, Ontario, Canada. Since 2002 it has been a part of the Linamar Corporation, which manufactures engines and related mechanical systems.

Physical Specifications

  • The work height of the Skyjack SJIII 3220 is 26 feet, meaning that it can be used 26 feet above ground. The raised platform height is 20 feet, and the lowered platform height is 38 inches.

    This platform lift has an overall width of 36 inches, and its overall length is 91 1/2 inches. When stowed for storage with the rails up, it is 77 1/2 inches tall, and when stored in its optimal rails down position, its height is 63 1/2 inches. The platform measures 28 inches wide by 84 inches long --- based on inside measurements --- and a 3-foot extension base is included.

    The wheelbase of the Skyjack SJIII 3220 measures 69 inches. Its ground clearance when raised is 3.5 inches, and when stowed the ground clearance is 0.75 inches.

    The entire unit weighs 3,510 lbs, and it operates on a 24-volt DC power source which is included.

Power and Performance

  • When raised, the drive speed of the Skyjack SJIII 322 is 1.1 miles per hour, and this increases to 2 mph when the unit is stowed. The lift time with a rated load --- up to its capacity --- is 33 seconds, and gradeability is rated at 25 percent. The inside turning radius is 50 inches, and the outside turning radius is 108 inches.

    The unit is equipped with dual holding brakes, and a variable speed, rear two-wheel hydraulic drive.


  • The overall capacity of this scissors lift platform is 900 lbs. It accommodates a maximum of two people. It can be driven at its full 26-foot height.

Other Specifications and Features

  • The Skyjack SJIII 322 features low voltage battery protection, solid rubber non-marking tires and a pothole protection system. It is also equipped with an operator horn, a tilt alarm and an all-motion audible alarm.

    It has an analog control system, with proportional controls for drive and lift functions as well as a color-coded and numbered wiring system. A 110V AC outlet is installed on the platform for use with power tools.

Related Searches


Promoted By Zergnet


You May Also Like

  • DIY: Platform Beds

    A platform bed is certainly one of the easiest bed frames to build on your own, and is arguably one of the...

  • Gardner Denver Mud Pump Specs

    Gardner Denver is a publicly-held company that produces oilfield pumps, centrifugal blowers, compressors, channel blowers and water-jetting systems. The company was started...

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

Is DIY in your DNA? Become part of our maker community.
Submit Your Work!