×

How to Solder Copper Sheet Metal

C.L. Rease

Soldering copper sheet metal is a fundamental part of applying a copper roof to your home. The solder seals the connections between copper sheets from water intrusion. To successfully solder copper sheets, you will need to ensure that the copper sheets, soldering iron and the solder are perfectly clean. If any contaminants are present while soldering, the puddle of melted solder will not flow properly and there will be voids left in the solder joint.

Step 1

Place the electric soldering iron on the worktable and turn it on.

Step 2

Lay the copper sheets that you need to solder flat on top of the worktable.

Step 3

Pour a small amount of liquid rosin solder into the small glass jar. If you apply flux directly from the can, you risk contaminating the entire can of flux.

Step 4

Lay the Sal ammoniac cake on the surface of the worktable.

Step 5

Tin the surface of the hot soldering iron. Place the head of the iron on the surface of the Sal ammoniac cake and then melt the lead-free solder on the head of the soldering iron. Rub the solder-covered head onto the Sal ammoniac cake and flip the soldering iron.

Step 6

Repeat the procedure from the previous step on the other three sides of the soldering iron head.

Step 7

Dip the acid brush into the small glass jar of liquid rosin acid and brush the two surfaces of the copper sheet that are going to be soldered together.

Step 8

Lap the fluxed pieces of copper to form the solder joint.

Step 9

Rest the tinned head of the hot soldering iron on the surface of the lowest piece of lapped copper.

Step 10

Place the lead-free solder directly onto the head of the soldering iron as you pull the iron across the lapped copper sheets. The liquefied solder will run directly into and over the lapped joint.

Step 11

Tin the head of the soldering iron before you solder each weld joint to ensure that the solder runs freely into the solder joint.