How to Remove a Breaker From a Panel

eHow may earn compensation through affiliate links in this story. Learn more about our affiliate and product review process here.

Things You'll Need

  • Flashlight

  • Screwdriver

  • Wire cutters (optional)

Removing a circuit breaker takes only a few minutes.

Removing a circuit breaker from an electrical service panel is one of the easiest electrical projects any do-it-yourselfer can tackle. The process takes only a few minutes and requires just a screwdriver. Circuit breakers are quite durable and generally do not wear out, so it is uncommon to have to replace a faulty breaker. Also, breakers that are not connected to a circuit can remain in place, so it might not be necessary to remove the breaker at all.

Advertisement

Disconnecting a Circuit and Breaker

Step 1

Turn off power to the service panel at the main breaker.

Video of the Day

Step 2

Remove the cover to the panel by unscrewing the fasteners located in the corners of the cover.

Advertisement

Step 3

Locate the electrical cable that supplies the electricity to the circuit you are disconnecting. The cables enter the panel through knockout holes and are held in place with cable clamps. Unscrew the clamp and lock nut securing the cable.

Step 4

Disconnect the white (neutral) and ground wires. The neutral wire is connected to a terminal on the neutral bus usually located on the side of the panel. The green ground wire is either connected to the same neutral bus or to a ground bus with green terminals.

Advertisement

Step 5

Grasp the exposed end of the breaker where the black (hot) wire is attached. Pry up the end until the breaker unclips from the hot bus bar. You should not have to use much force.

Step 6

Disconnect the black wire from the breaker by unscrewing the set screw. Cut the wire if necessary and remove the electrical cable by pulling it through the knockout.

Advertisement

Step 7

Reattach the cover to the service panel. Turn off all breakers in the service panel to avoid power surges in the circuits when electricity is restored. Turn on the power at the main breaker and reset the other breakers.

Removing and Replacing a Breaker

Video of the Day

Step 1

Turn off the power at the main breaker and remove the cover to the service panel. Remove the cover to the panel by unscrewing the fasteners located in the corners of the cover.

Advertisement

Step 2

Grasp the exposed end of the breaker where the hot wire is attached. Pry up the end of the breaker until it unclips from the hot bus bar.

Step 3

Disconnect the black wire from the breaker and attach the wire to the new breaker. You do not need to touch the neutral or ground wires if you are not replacing the breaker. If so, disconnect the neutral and ground wires from their buses and remove the electrical cable from the service panel.

Advertisement

Step 4

Snap the new breaker into place by clipping it to the hot bus bar. Reattach the cover to the service panel.

Step 5

Turn off all breakers in the service panel to avoid power surges in the circuits when electricity is restored. Turn on the power at the main breaker and reset the other breakers.

Advertisement

Report an Issue

screenshot of the current page

Screenshot loading...