Plan the perfect garden with our interactive tool →

What Size Gravel to Backfill Fence Posts?

Gravel is a common backfilling for fence posts and comes in a variety of types. Some gravel comes mixed with sand to make it finer, while other gravel is made of crushed rock. For most projects, size will make a difference. There are a couple of major factors to keep in mind when choosing gravel for fence post holes.

Drainage

When a fence post hole is dug, it creates a place for water to collect. This isn't a problem for the ground, but when you put a wooden fence post there, the collected water can cause the wood to rot over time. For metal fence posts, it will cause rust. Larger sized gravel will allow the water to drain through to the ground below so that the post isn't sitting in stale water for long periods of time. Overly large gravel will not sit in the hole as well, and the fence post will lack support.

  • Gravel is a common backfilling for fence posts and comes in a variety of types.
  • This isn't a problem for the ground, but when you put a wooden fence post there, the collected water can cause the wood to rot over time.

Post Support

Finer gravel will provide a more secure bottom for the fence post to set on. If the gravel is too fine, however, water will not drain through as well and may end up collecting around the fence post. For this reason, gravel mixed with sand, and extra fine gravel should be avoided.

What to Use

Pea gravel is commonly used for fence post holes. Gravel that is roughly three eighths of an inch in size is generally a good medium between drainage and support, though gravel close to that size also may be used. If you want to use the best gravel for your area, you may want to consult a contractor. They will know what kind of support is needed based on ground and weather conditions.

  • Finer gravel will provide a more secure bottom for the fence post to set on.
  • If the gravel is too fine, however, water will not drain through as well and may end up collecting around the fence post.

Set Fence Posts Using Pea Gravel

Wear gloves to protect hands when working. Make the hole twice as large as the post diameter. Level the post front to back and side to side with a construction level. Continue to add 6 to 8 inches of gravel at a time and then pack it with a tamp. Check with the construction level and add more gravel until the hole is filled to within 8 inches of ground level. Add water to moisten the concrete and allow to set overnight. Figure on about a gallon per 50-pound bag of concrete.

  • Wear gloves to protect hands when working.
  • Add water to moisten the concrete and allow to set overnight.

Related Articles

How to Do Footings for Steel Posts
How to Do Footings for Steel Posts
How to Build a Dock for a Pond
How to Build a Dock for a Pond
How to Dig a Hole for a Pool
How to Dig a Hole for a Pool
How to Stabilize a Clothesline Post
How to Stabilize a Clothesline Post
How to Build a Brick Driveway
How to Build a Brick Driveway
Cutting Cedar Trees to Use As Fence Posts
Cutting Cedar Trees to Use As Fence Posts
How to Tie Wooden Posts to Cement Blocks
How to Tie Wooden Posts to Cement Blocks
How to Lay Landscaping Fabric Behind a Retaining Wall
How to Lay Landscaping Fabric Behind a Retaining Wall
How to Stabilize a Pergola
How to Stabilize a Pergola
How to Install a Chicken Wire Fence
How to Install a Chicken Wire Fence
How to Anchor a Garden Arch
How to Anchor a Garden Arch
Why Should You Put Gravel Under a Deck?
Why Should You Put Gravel Under a Deck?
Gravel Size for a Driveway
Gravel Size for a Driveway
How to Make a Stone Waterfall
How to Make a Stone Waterfall
Garden Guides
×