Difference Between 3.50-18 & 11090-18 Tires


Many new motorcycle tires are sold using metric size designations, while many vintage motorcycles through the early 1980s came equipped with tires measured using inch-based designations. Using basic math and conversion tables or fitment guides offered by tire manufacturers, it is simple to choose a metric-sized tire to replace older inch-designated tires.

Deciphering Tire Size Designations

  • Inch-based tire designations (e.g., 3.50-18) contain only two pieces of size information, the section width (3.50 inches) and the rim diameter (18 inches). Metric tire size designations (e.g., 110/90-18) contain three measurements, the section width (110 millimeters (mm)), the aspect ratio (90 percent), and the rim diameter (18 inches). The aspect ratio is the ratio of the tire's sidewall height to its section width. A 110/90 tire's sidewall height would be approximately 90 percent of 110 mm, or 99 mm.

Convert Inch-Based Designations to Millimeters

  • As a rough starting point for comparison, convert inch-based tire size measurements to millimeters. One inch equals 25.4 mm, so a tire with a section width of 3.50 inches would have an equivalent metric width of 3.50 x 25.4 mm/inch = 88.9 mm. This would most closely equate to a metric-sized tire with a 90 mm section width. Both inch-based and metric tire size designations use inches for the rim diameter, so no conversion is necessary for that measurement.

Aspect Ratio/Sidewall Height Considerations

  • Most older, inch-designated tires had sidewall heights approximately equal to their section width, so a 3.50 inch wide tire would also have a sidewall height of approximately 3.50 inches, or 90 mm.

    A 90/90-18 tire would have a sidewall height of 90 mm x 90 percent = 81 mm, about 8 mm (1/3 inch) less than the 3.50-18 tire. Although a small difference, this could affect the handling of the motorcycle or cause speedometer readings to be incorrect.

Consult Tire Manufacturer Fitment Guides

  • Since aspect ratios over 90 are not typically available, metric tires with a section width equal to older inch-based tires would have a shorter sidewall. Therefore, most tire manufacturer fitment guides recommend a slightly wider 100/90-18 tire, with a sidewall height of 90 mm (100 mm x 90 percent), as a replacement for the 3.50-18.

    A 110/90-18 tire would have an approximate width of 4.3 inches (110 mm / 25.4 mm/inch) and a sidewall height of 3.9 inches, so it would be both wider and taller than the 3.50-18 tire.

Related Searches


  • Photo Credit roue arriere de moto image by Christophe Fouquin from Fotolia.com
Promoted By Zergnet


You May Also Like

  • Specifications of Honda CM 400

    Styled to resemble cafe racers of the 1960s, the Honda CM400 motorcycle series was geared toward beginning riders with a small 395...

  • Understanding Interchangeable Tire Sizes

    Tire aspect ratio and load capacity are determining factors in understanding interchangeable tire sizes. The old tire sizing system was based on...

  • How to Compare Tire Sizes

    Comparing tire sizes is easy once you understand the various marking on the tire’s sidewall but keep in mind that there is...

  • How to Explain Golf Cart Tire Size

    Golf cart tires, along with tires for just about every other kind of vehicle, use a sizing code that is indecipherable to...

Related Searches

Check It Out

10 Delicious Game Day Eats That Rival the Game

Is DIY in your DNA? Become part of our maker community.
Submit Your Work!