×
Back Button

What Is the Correct Height Placement for Door Knockers?

Kathy Adams

While the best height to place a new door knocker depends upon the design of the door, 4 to 5 feet up from the bottom of the door suits most purposes.

There is no single height that works on all doors when it comes to door-knocker installation. Instead, choose a height between 4 and 5 feet from the bottom of the door, or the ground or flooring outside the door, centering the knocker from the sides of the door.

Eye-Level Alignment

Use an average adult eye-level height -- approximately 5.5 feet or slightly higher -- as a starting point for your door knocker placement decision. Measure from the ground-level standing position outside of the door, such as from the porch floorboards upward. Place a strip of masking tape at this height and see if it seems to be a good level to you and others sharing your home. If so, use the tape strip -- and potentially several others -- to mark dots on the door for exact knocker placement. Measure the center of the door from side to side and mark the tape at this point to ensure the center of the knocker lines up with the center of the door.

Tip

If you anticipate a lot of young visitors -- neighborhood children visiting your kids, for instance -- adjust the knocker placement downward at least a few inches so an older elementary-school child can reach it.

Off-Center Situations

In some cases, the door's design may not allow for a knocker at the 4 to 5 foot range -- a large window or etched glass may take up much of the upper door area. In this case, find a location along the non-glass portion of the door, such as the area above the doorknob, to install the knocker at the desired height.

Installing a Surface-Mount Door Knocker

A surface-mount door knocker installs with a few screws inserted through the outside of the knocker, into the door.

  1. Line the door knocker up at the desired height, centered from left to right.

  2. Position a level along the top of a flat-topped doorknocker, or across two parallel points on the front of the knocker, to ensure the knocker is straight. Adjust the knocker until it's straight.

  3. Use a pencil or marker to make dots on the door or masking tape through the screw holes in the knocker. Set the knocker, pencil and level aside.

  4. Drill pilot holes for the screws using a bit narrower than the screws included with the knocker.

  5. Tip

    Place a piece of masking tape on the drill bit to mark the desired drilling depth. Stop drilling when the tape reaches the door -- this ensures you won't drill all the way through the door.

  6. Line the door knocker up so the drilled holes in the door match the holes in the knocker. Place one screw in each hole.

  7. Tighten the screws with a Phillips screwdriver.

  8. Tip

    If the door is hollow, use plastic anchors to keep the screws stable. Drill the pilot holes in the door wide enough for the anchors to fit snugly in place. Use anchors designed to fit the screws, otherwise they will not hold the screws securely, which means the knocker could fall off the door.

The Drip Cap

  • There is no single height that works on all doors when it comes to door-knocker installation.
  • In this case, find a location along the non-glass portion of the door, such as the area above the doorknob, to install the knocker at the desired height.
  • Adjust the knocker until it's straight.
  • Use a pencil or marker to make dots on the door or masking tape through the screw holes in the knocker.