How to Install a Graphtec FC 7000 Two Pen Holder
Engineers and architects alike utilize a special piece of equipment called a "plotter" to print out blueprints. Because the blueprints have to be printed on large, rolled out sheets of paper, standard computer printers cannot do this job adequately. The Graphtec FC-7000 is a plotter that uses a two-pen holder system for cutting the roll of blueprint paper once the document is complete. Installing the pen holder takes approximately 30 minutes.
Other People Are Reading
Instructions
-
-
1
Unplug the plotter from the wall if it has been in use.
-
2
Flip the lid up on the plotter in order to access the pen holder.
-
-
3
Turn the pen screw to the left by hand.
-
4
Push the pen holder in until the flange contacts the base of the holder.
-
5
Twist the pen holder screw to the right to tighten it down.
-
1
