How to Change the Drive Belt on Honda HRR2162SDA Mower
The Honda HRR2162SDA push mower utilizes a rear driven transmission to make it easier to use the mower. When you push down on the drive lever, the mower propels forward. It uses power from the motor shaft and a pulley system to operate the transmission. Eventually the belt wears out and when you push in on the drive lever, the belt will simply spin on the pulleys. When this happens, replace the belt with a new one. Does this Spark an idea?
Other People Are Reading
Instructions
-
-
1
Remove the grass collector bag from the back of the mower.
-
2
Locate the transmission housing cover. Remove the screws that hold the cover onto the top rear of the mower deck.
-
-
3
Loosen the setscrew on the transmission to loosen tension on the drive belt. With tension released, pull the drive belt off the transmission pulley.
-
4
Push the drive belt through the hole in the mower deck.
-
5
Place the mower deck on its side so the air cleaner faces upward. Do not place the deck so the air cleaner faces downward.
-
6
Remove the two bolts that hold the blade onto the motor shaft with a wrench. Take the blades off the shaft.
-
7
Locate the drive pulley mounted to the shaft and then pull the belt off the pulley.
-
8
Place the new belt onto the pulley and then push the other end through the hole in the mower deck.
-
9
Slide the belt over the transmission pulley and then tighten the tensioning setscrew.
-
10
Place the cover back onto the transmission housing and secure it with the screws.
-
11
Place the mower blades back onto the mower shaft and secure them with the bolts and the wrench.
-
1
