How to Repair Rotten Weatherboards

Save

Rotten weatherboards can cause many problems for homeowners. In addition to cosmetic issues, compromised weatherboarding creates an entry point for insects and rodents, and is a breeding ground for potentially dangerous mold. Repairing your rotten weatherboards increases your house's longevity as well as its appraisal value. Fortunately, a damaged weatherboard can be replaced with a minimal amount of remodeling experience, and without significantly affecting the surrounding boards.

Things You'll Need

  • Crowbar
  • Pencil
  • Circular saw
  • Stud finder
  • Hammer
  • 3/4 inch nails
  • Silicone caulk
  • Remove the damaged weatherboarding, as well as any undamaged weatherboarding surrounding the affected area. Apply gentle pressure to the seams between the weatherboards using a crowbar until the nails loosen. Discard the damaged weatherboarding. Remove the nails from the undamaged weatherboards and set them to the side.

  • Examine the area behind the weatherboards for water damage. If there appears to be warping, heavy discoloration or extensive rot or mold, consult with a professional before proceeding.

  • Lay the damaged weatherboard on top of a new piece of weatherboarding. Use a pencil to mark the edge lines of the damaged weatherboard onto the new piece.

  • Cut the new weatherboard to length, using a circular saw.

  • Locate the studs in the damaged section of the wall, using a stud finder. Mark the edges of each stud with a pencil.

  • Reinstall the weatherboarding. Work from the bottom piece up toward the top, nailing each piece of weatherboard at the top of the strip using a hammer and 3/4-inch nails. Drive your nails into the marked studs to ensure a secure installation. If there is weatherboarding still in place above the damaged area of the wall, you might need to loosen it slightly in order to slot the lower pieces back into place.

  • Seal all seams around the new weatherboarding with a high-quality, clear silicone caulk. Allow the caulk to dry thoroughly.

Tips & Warnings

  • Always take appropriate safety precautions when using a circular saw. Pull back long hair, remove jewelry and wear safety glasses.

References

  • Photo Credit Polka Dot RF/Polka Dot/Getty Images
Promoted By Zergnet

Comments

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!