How to Install a Hanging Shelf in Garage or Workshop

The first step in building your hanging shelf is to mount the supports. If unable to locate the ceiling joists, use a stud finder to locate them. Cut 4 sections of 2x4 at least 30'' long to span the width of the ceiling joists. Determine where at least one corner of the shelf will end (against a wall) and make a mark on the ceiling for it. Measure 4' into the room from the mark and make another. Measure 8' along the length of the room from each of these two marks and place marks as well. Center your 2x4 sections over your mark so that they cover at least 2 ceiling joists and attach with the 4'' hex head wood screws. You should end this step with 4 ceiling blocks firmly attached making a basic 4x8 outline.

Now you can attach your steel brackets. Starting in the same corner, attach the brace to the 2x4 section with a 4'' hex screw so that one edge of the brace faces the block and the other side faces the area where the shelf will be. Measure exactly 8' from the brace to next block and install a brace in the same way. Mark corresponding spots on each of the outside blocks and install braces on them as well.

To build your shelf cut two 8' 2x4 sections and five 45'' sections. Measure and mark each of the 8' sections. Place marks every 24''. You should have 3 marks evenly spaced. Place the two 8' sections parallel to each other and 45'' apart. Place each of the shorter sections in between the 8' boards so that the center of the ends matches the marks on the long sections. Place the other two 45'' sections at each end so that they are flush with the ends of the long sections. Attach all connections with the 2.5'' wood screws. Place a 4x8 sheet of plywood over the frame, make sure that each corner is square and attach with 1.5'' wood screws. (you can install the plywood later to make the shelf easier to lift into place)

Use scaffolding, ladders, or other support structure to place the shelf at the desired height with one long end flush to the wall. Starting with one brace, bend it (at the base) a few inches out of perpendicular and away from the wall and attach to the shelf with 4'' hex screws. By bending the brace slightly, gravity will push the shelf tight to the wall and the shelf will not wobble. Using a level to make sure the shelf is perfectly even and connect the other three braces in the same way.

Test the shelf for load bearing by placing at least your own body weight worth of cinder blocks or other item. Remove any excess length of steel brace by grinding off or sawing with a hacksaw. Now you can enjoy your extra storage space without losing any floor space.