Guitar cases are meant to be sturdy and reliable, keeping your instrument safe from damage or accidents. Many guitar cases are not made from the strongest of materials, however, and tears, rips and loose parts are common occurrences. One of the most common complaints of guitar players is that the case's handle breaks -- or even snaps off entirely. There is a quick, easy fix for a broken guitar-case handle that many musicians use in a pinch, and another more permanent fix that takes just a couple of extra steps to complete.
Things You'll Need
- Duct tape
- Guitar case handle
- Wire cutter
- 2 split rivets
Pull off three to four feet of duct tape and wrap it up like a cocoon, using a motion with your hand and wrist that is the same as reeling a fishing pole. This piece is the actual handle you will grab.
Bend the handle into a crescent shape.
Place the ends of the handle onto the case above where the previous handle existed.
Use the scissors to cut off several pieces of duct tape about four inches long and wrap them around the ends of the handle so that it firmly attaches to the case.
Pick up the case with the handle to make sure it is secure enough. Use more duct tape if necessary.
Take your guitar out of the case and remove any pieces of the broken handle that remain attached to the case.
Remove the original rivet by snapping it in half with the wire cutter.
Slide the new handle into place between the holders on the original piece of hardware.
Slide the split rivets through the hardware with the flat ends on the inside of each end of the handle.
Bend the split ends of the rivets as close to a 90-degree angle as possible, to hold the handle in place.
- Photo Credit Jupiterimages/liquidlibrary/Getty Images
How to Remove Mold in Guitar Cases
It is very important to keep your guitar case clean. It should also be stored in areas that are dry and well-lit...
How to Repair a Broken Guitar Case
Guitar cases take a real beating. They are made from plywood or chipboard with a vinyl coating called Tolex. They are not...