How to Build a Puppet Theater With Wood


The simplest puppet theaters are screens that hide the performers, with an opening at the top where the puppets emerge. These are usable, but a stage with a curtain the puppets can perform in front of while the performers are standing or seated is much easier. A folding stage, with a curtain, can be made from a single sheet of heavy plywood and a piece of piano hinge. The plywood is light enough to move easily, but heavy enough to stand without a frame.

Things You'll Need

  • Tape measure
  • 3/4-inch-thick plywood
  • Table saw
  • Drywall square
  • Drill
  • Paddle bit
  • Jigsaw
  • Sandpaper
  • Sander
  • Piano hinge
  • Hacksaw
  • Wood screws
  • Black polyester fabric
  • Air stapler


  • Use a table saw to saw a 24-inch length from each end of a sheet of 3/4-inch-thick plywood, creating two 24-by-48-inch pieces and one 48-by-48-inch piece.

  • Use a drywall square to draw a rectangle 18 by 36 inches, centered in the 48-by-48 inch piece of the plywood. Drill a hole in one corner of the rectangle with a 1-inch paddle bit.

  • Start a jigsaw inside the 1-inch hole and cut out the rectangle.

  • Sand the three plywood panels with 100-grit sandpaper on a random-orbit sander. Concentrate on the edges, removing any splinters.


  • Cut a 96 inch piece of piano hinge in half with a hacksaw to create two 48-inch long hinges. Lay the three plywood panels down flat. Fit one 24-by-48-inch piece against the side of the 48-by-48 inch panel, with the rectangle opening toward the top and the smaller panel on the right edge, with its 48 inch edge aligned to the larger panel.

  • Attach the hinge along this joint, face mounted, using one 1/2-inch wood screw in each hole. Use a cordless drill to drive the screws. Fit the remaining 24-by-48-inch panel against the other side of the larger panel and attach it using the remaining hinge, face mounted with one 1/2-inch screw in each hole.

  • Stand the stage upright with the two smaller wing panels, standing at right angles to the larger stage panel, supporting it.

  • Cut out a 20-by-46-inch piece of sheer black polyester fabric. Staple one long edge of it along the top of the stage opening on the hinged side of the panel, 1/2 inch above the edge, using 1/2-inch narrow crown staples from an air stapler, one every 3 inches.


  • "Making Toys for Preschool Children"; Linda G Miller; 2002
  • "Jim Tolpin's Table Saw Magic"; Jim Tolpin; 2004
  • Photo Credit Hemera Technologies/ Images
Promoted By Zergnet


You May Also Like

Related Searches

Read Article

How to Build and Grow a Salad Garden On Your Balcony

Is DIY in your DNA? Become part of our maker community.
Submit Your Work!