How to Fix Hot Tub HFL Errors


If your hot tub display panel displays an error code, don't necessarily think you should call the service center. You can take care of many errors yourself. The "HFL" error normally indicates a substantial difference between the sensors in your unit, and is normally caused by a water flow issue. Fixing the error codes should only take a few minutes. Before doing anything else to your hot tub, check the circuit breaker and ensure that the unit has power. Error codes may go away when power returns to a unit.

  • Check the water level in your hot tub. Keep water about 1 inch above all the jets when there is nobody in the hot tub. As people get into the hot tub, the water level will naturally rise.

  • Ensure that the slide-valves, located inside the access panel, are open. The slide-valve is a "T" shaped panel that is pulled up when "open" and is pushed down when "closed."

  • Prime the pump to remove air out of the pipes. Loosen the pump union slightly to let any trapped air escape the pipes, and then tighten it back up. Turn the pump on and listen for normal jet sounds.

  • Clean the hot tub traps and skimmer baskets regularly to keep debris from entering the system.

Tips & Warnings

  • Error code "LF" indicates a persistent low flow problem. If the "HFL" code displays five times the heater will turn off, but other functions of the hot tub will still work. Call a repair person to determine why your hot tube has persistent problems.


  • Photo Credit Jupiterimages/BananaStock/Getty Images
Promoted By Zergnet


You May Also Like

  • How to Fix a Hot Tub

    Whether you've just purchased a home with a hot tub, or you've installed a brand new hot tub yourself, there's nothing worse...

  • How to Wire a Heat Pump Thermostat

    When you install a heat pump in your house to replacing the existing furnace, you must also replace the existing thermostat with...

  • How to Wire a GFCI Circuit Breaker

    The Ground Fault Circuit Interrupter (GFCI) saves lives. There are two different kinds for home use--electrical outlets and circuit breakers. GFCI circuit...

  • How to Fix a Crack in a Hot Spring Tub

    Few things are more relaxing than enjoying your own personal Hot Spring tub. Hot tubs are a major investment and can provide...

  • Whirlpool Duet Error Code F71

    The Whirlpool Duet series of washers comes with a set of built-in error codes so that owners and repair technicians can easily...

  • How to Fix a Heavy Hot Tub Cover

    When your hot tub cover gets heavy it is from water that has accumulated inside the open cell foam. You can replace...

Related Searches

Read Article

Make an Ikea Lack Table Look Expensive With This Cheap Hack

Is DIY in your DNA? Become part of our maker community.
Submit Your Work!