A thumb spica splint is a partial cast designed to immobilize the thumb. Commonly used in emergency rooms, the splint combines hard plaster and bandages, which treat injuries like sprains and minor fractures. For severe injuries, it temporarily immobilizes the thumb until surgery is performed. After surgery, a thumb spica splint helps in the healing process.
Things You'll Need
- Webril cotton padding
- 10 sheets of plaster
- Water bucket
- Bandage wrap
- Bandage tape
- Bandage clips
Place the stockinette over the hand and pull it down to the middle of the forearm. Cut openings for the fingers and the thumb. Wrap Webril cotton padding around the thumb, palm and to the middle of the forearm. Apply extra padding around the bony protrusions of the thumb and wrist joints.
Measure plaster sheets. An average-sized adult splint requires 10 plaster sheets, 3-inches wide. Lay the plaster from the tip of the thumb to the middle of the forearm. Cut the top section of the plaster into two stripes using a scissor to allow for easier molding of the thumb.
Submerge the plaster in a bucket of water. Remove the wet plaster, squeeze out excess water and place on a towel to remove wrinkles and folds.
Apply the wet plaster to the top of the thumb and forearm. Mold the plaster around the thumb, making sure to smooth the edges, so they do not become sharp.
Apply a bandage wrap over the wet plaster, starting at the thumb, wrapping around the hand and finishing at the middle of the forearm. Refrain from wrapping too tightly. Secure the end of the wrap with either bandage tape or clips.
Finish molding the plaster while it is still wet. During this time, the patient remains still while placing his hand in a position similar to holding a glass. This should be done until the plaster has dried.
Check if the splint is too tight by inspecting the thumb and fingers for any redness or swelling. Ask the patient if he can move his fingers freely without discomfort.