Shower ceilings typically include a soffit made of plaster or drywall. During the many uses of the shower, moisture and air are drafted upward, leaving condensation on the ceiling, particularly when the water is hot. If the bathroom is not well ventilated or does not have a working exhaust fan, mold may begin to form on the ceiling. The combination of air and moisture causes the ceiling to become discolored and sag. But it can be repaired to look like new.
Things You'll Need
- Dish soap
- Safety goggles
- Dust mask
- Utility knife
- Reciprocating saw
- Tape measure
- 2-by-4-inch lumber
- Circular saw
- Nail gun
- Moisture-resistant drywall panel
- Drywall screws
- Screw gun
- Drywall tape
- Joint compound
- Putty knife
Inspect the shower ceiling for mold. Wash the mold away with soap and water using a sponge and dry with a cloth. If the mold problem is too large, go to Step 2.
Pull down the damaged portion of the shower ceiling. Put on safety goggles and a dust mask. Score an outline around the damaged area 4 to 6 inches larger than the affected ceiling. Use a reciprocating saw if necessary. Square the damaged portion so it is even on all sides.
Measure the cut-out section with a tape measure and write down the dimensions. Mark and cut a section of drywall from a new moisture-resistant drywall panel to patch the shower ceiling.
Fasten the new drywall to the ceiling beams with drywall screws using a screw gun. If no beams are immediately above the cut-out section, cut 2-by-4-inch lumber to fit with a circular saw. Fasten the lumber to the nearest ceiling beams with a nail gun. Tape the joints with drywall tape and spread joint compound over the whole patch with a putty knife, including the taped joints.
Sand the patch thoroughly to prepare it for primer and paint to conceal the patch. Make the joints smooth and even to better conceal the patch.
Apply a coat of primer to the patch with a roller, extending a few inches beyond the patch's borders. Let the primer dry for at least two to three hours. Apply the first coat of paint with a roller. Allow the first coat to dry to determine how many more coats will be needed to match the rest of the shower ceiling. Apply additional paint coats as necessary.
- "Black & Decker Working with Drywall: Hanging & Finishing Drywall"; Creative Publishing International; 2009
- "Find It, Buy It, Fix It: The Insider's Guide to Fixer-Uppers"; Robert Irwin; 2006
How to Install Waterproof Drywall and Tiles in a Shower and Tub Area
Installing drywall and tiles in a shower and tub area has to be done with care, because of the moisture present in...
How to Repair a Bathroom Ceiling
Bathroom ceilings can develop problems because of constant moisture. Leakage from another bathroom above also may occur. This can lead to mold,...
How to Repair a Pop-Up Camper Roof
A pop- up camper is an economical way to camp. This type of camper is pulled behind a car, SUV or van...
How to Fix Holes in a Ceiling
Patching walls in ceilings requires the same technique as walls. It is complicated slightly by the fact that you are working over...