Remington Power Hammer Instructions

Save

The Remington Power Hammer Model 476 uses low-velocity .22 caliber cartridges to drive fasteners into steel, concrete and masonry. The hammer is designed to operate with .22 caliber crimped Remington Powder Loads Type A. It can drive Remington Power Fasteners up to 2-1/2-inches long. Penetration in concrete is between one inch and 1.25 inches. In steel, the fastener must fully penetrate the material, with recommended steel applications in the 3/16-inch to 5/16-inch range.

Loading

  • Insert the fastener into the end of the muzzle of the Power Hammer, with the round metal head first. Continue to push the fastener into the muzzle until its point is even with the end of the muzzle.

  • Open the chamber by pulling forward on the muzzle until it reaches its limit.

  • Hold the muzzle down and away from you. Insert a Remington Powder Load of the appropriate power rating into the chamber.

  • Push the barrel down into the hammer housing until it stops, and hold it there.

Firing

  • Hold the muzzle of the Power Hammer flush against the surface of the working material at a 90-degree angle. Do not tilt it.

  • Hold the grip of the muzzle with one hand and push down to compress the spring. The groove etched on the barrel must align with the groove on the housing before the Power Hammer will operate correctly.

  • Hit the firing pin at the top of the hammer with a one-pound hammer using a strong, sharp blow. If the Power Hammer does not fire, wait thirty seconds, then eject the Powder Load and repeat the loading/firing procedure.

  • Remove the tool from the surface of the material after firing. Pull the barrel forward rapidly to eject the spent Powder Load.

References

Promoted By Zergnet

Comments

You May Also Like

  • How to Repair Remington Powder Actuated Tools

    Powder actuated tools are most often used to drive nails into concrete. The design is similar to a long-barreled hand-gun except it...

  • How to Install Drywall on a Concrete Wall

    Installing drywall on a concrete wall will help you finish your basement or garage the way you want it. It takes a...

  • How to Use a Masonry Nailer

    There is a contractor for every phase of construction, including the masonry. Masons work with concrete, stone and block. They also build...

  • How to Disassemble Remington Shavers

    Remington electric shavers can be disassembled with a few basic household tools, whether you want to replace the rechargeable batteries or take...

  • How to Operate a Ramset Hammer With Charge

    Powder actuated fastening is a quick and easy way to complete heavy fastening projects with minimal effort. Using a Ramset hammer is...

  • How to Use Ramset

    Ramset powder actuated tools secure materials to both concrete and steel quicker than standard drilled fasteners. Although efficient, Ramset tools are powder...

  • How to Use a Powder Actuated Nail Gun

    Construction workers use a powder actuated nail gun to drive nails through the bottom wall plate and into the concrete slab for...

  • How to Use a Remington 490

    The Remington Model 490 Powerdriver is a powder-actuated, hand-held tool that resembles a power drill, but functions similarly to a firearm. The...

  • Types of Fasteners to Fasten 2X4 Wood to Concrete

    A walk through a hardware store's fastener aisle inundates the do-it-yourselfer with concrete anchoring options including pins, screws, nails, sleeves and bolts....

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!