Torque steering -- when your motor tries to pull the stern of the boat in the direction in which the propeller turns when you're backing the boat -- is one of the small problems you deal with on a boat with a single propeller. When a boat moves, only one side of the propeller digs into the water as it turns, pulling the stern of the boat in the same direction. The solution lies in a device called a trim tab.
Things You'll Need
Observe the direction in which the stern of the boat moves when you back up. If the stern moves to port, that means you need to exert a force on the starboard side of the motor.
Locate the trim tab. If your boat is powered by an outboard motor, the trim tab will be attached to the bottom of the horizontal cavitation plate that looms above the propeller. The trim tab resembles a small boat rudder. In the center of its base is a nut.
Loosen the nut with a socket. If the stern of the boat moves to port, adjust the trim tab to starboard. If the boat moves to starboard, adjust the trim tab to port. Tighten the nut securely.
Watch how your boat behaves when you back it; readjust the trim tab to fine-tune its effect on your boat, if necessary.
Adjust hydraulically-controlled trim tabs on boats with inboard and inboard/outboard motors by lowering the trim tab on the side of the boat opposite the direction in which the stern pulls when backing; if it pulls to port, lower the starboard trim tab; if to starboard, lower the port tab. Raise the trim tabs when moving forward.
Tips & Warnings
- You probably will never get rid of torque steering completely, but if you eliminate most of it using a trim tab, you'll learn to compensate for -- and even use -- the bit that's left.
- Disconnect the negative cable of your battery before performing this work on your outboard motor, to prevent electrical shock or accidental starting. Remove the nut from the negative post with a 5/16-inch box-end wrench -- the nut on the negative post of a marine battery is always a 5/16-inch nut. If the wrench doesn't fit, you're trying to remove the 3/8 nut on the positive post. Lift the cable from your battery, move it outside of the battery box and close the lid of the battery box.
- "Evinrude Repair Manual -- 2.5 to 250 HP Models, 2002-2007"; Seloc Marine; 2007
- Photo Credit Hemera Technologies/AbleStock.com/Getty Images
How Do I Set My Torque Trim Tab on My Outboard Motor?
Torque trim tabs help to counteract the effects of torque, or wheel-walk, on the vector of the boat. Wheel-walk is a phenomenon...
How to Calculate Thrust Load in Helical Gear
Helical gears are spur gears that have their teeth set at an angle with respect to the axial center line of the...
How to Stop Torque in an Outboard Motor
The propeller on a boat, whether an outboard or inboard, creates an effect often termed wheel-walk when it spins. As the boat...
How to Calculate Boat Propeller Torque
Propeller torque is an important piece of data in determining what a boat can do. While you may know the amount of...
How to Clean the Teleflex Steering Cable on a Boat
Teleflex Marine makes boat steering systems, gauges and cables for a variety of applications, including your outboard motor. Taking care of the...