JumpKing Enclosure Instructions

JumpKing enclosures allow your children to jump safely on your trampoline.

Wouldn't it be nice to allow your children to play and jump on your trampoline without fear of their falling off and getting injured? JumpKing enclosures are designed to attach to your trampoline and act as a safety net to prevent this very scenario. The safety net runs completely around the edge of the trampoline and is about 8 feet tall. The frame poles of the JumpKing enclosure attach to the frame poles of the trampoline to support the safety net.

Things You'll Need

• Adjustable wrench

Instructions

1. Check your JumpKing enclosure parts against the parts list provided by the manufacturer to make sure you have all the parts necessary to install your enclosure.

2. Place a snap clip on all the suspension cords. Push in the flexible clip with your finger and place the suspension cord in the clip. Repeat this step on all the suspension cords.

3. Stand a vertical enclosure pole next to one of the vertical leg assemblies on the trampoline. Attach an upper clamp to the top of the vertical enclosure pole and trampoline leg assembly. Place a locking nut and washer on the 1 3/4-inch bolt provided by the manufacturer. Insert the bolt into the threaded hole on the clamp and tighten the clamp finger tight. Attach the lower clamp to the trampoline leg pole. Lift the vertical enclosure pole and slide it into the other end of the lower clamp. Place a locking nut and washer on another 1 3/4-inch bolt. Insert the bolt into the lower clamp. Tighten the lower clamp finger tight. Repeat this step until all the clamps have been attached to the poles.

4. Using an adjustable wrench, turn the nut clockwise to tighten the clamps securely. Place a cap nut on each of the locking nuts around the enclosure poles. Press the cap onto the nut with your finger until it covers the cap snugly.

5. Slide a swedged pole into one of the vertical enclosure poles. A swedged pole is a vertical pole that is narrow on one end. Repeat this step around the trampoline until all the swedged poles have been inserted into the vertical enclosure poles.

6. Cover the vertical enclosure pole assembly with a foam sleeve provided by the manufacturer. Place two suspension cords around the vertical pole assembly and sleeve. Adjust the suspension cords so the D-ring wraps around the pole. A D-ring is a metal piece that is shaped like an open D and fits the shape of the pole to prevent the cord from slipping. Repeat this step around the trampoline until all the poles are covered with the foam sleeves and suspension cords.

7. Place a pole cap on top of each vertical pole and press down firmly with your hand until it is properly seated.

8. Attach the safety net to the V-rings on your trampoline and the loops on the net. The V-rings are the triangular rings that surround your trampoline and connect the mat to the frame. Thread rope between the V-rings on your trampoline and the loops on your safety net, alternating between the two, along the bottom of the net. Tie the end of the rope to a V-ring after it has been threaded between the net and the V-rings.

9. Attach the snap clips of the suspension cords to the loops along the top of the net until all the clips are securing the net.

References

• Jumpking: Fun Ring User's Manual