How to Cut Hard Rubber

Save

Hard rubber is a generic name for the product called Vulcanite. Vulcanite was first created by Goodyear, who gave it the brand name Ebonite. The hard rubber is used in products such as the outside body of fountain pens and musical instrument mouthpieces. Use a miter saw when cutting hard rubber, which will allow you to hold the product in a safe manner to reduce slipping while making precise cuts.

Things You'll Need

  • Tape measure or ruler
  • Brightly colored felt tip marker
  • Miter saw
  • Finish blade
  • Water-based lubricant
  • Measure the length of hard rubber needed with a tape measure or ruler and mark the measurement on the rubber with a brightly colored felt tip marker for easy visibility.

  • Attach a finish blade that has 60 or more cutting teeth to the miter saw. Slide the miter saw's blade guard back to expose the blade. Spray both sides of the exposed cutting blade slightly with a water-based lubricant. Release the guard so that it covers the blade.

  • Lay the hard rubber on the miter saw's table so it lies firmly against the back fence. Slide the rubber piece so the line where the cut will be made rests at the center of the miter saw table's blade opening.

  • Swing the miter saw blade down until it rests on top of the hard rubber and adjust the rubber piece so that the line matches up with the blade. Allow the miter saw blade to swing up and then squeeze the saw's power trigger, which is on its handle.

  • Hold the rubber piece firmly against the miter saw's back fence, making sure your fingers are not in the way of the cutting blade. Swing the miter saw down slowly so that the blade cuts completely through the rubber.

  • Release the miter saw's power trigger while the blade is still pushed all the way down and allow the blade come to a complete stop. Swing the miter saw up and then remove the rubber. Make additional cuts as needed.

  • Inspect the saw for defects such as cracks in the casing, missing safety guards or electrical cords that have exposed wires before using it to avoid bodily injuries.

Tips & Warnings

  • Wear safety glasses and hearing protection when operating power tools.

References

  • Photo Credit Jupiterimages/Photos.com/Getty Images
Promoted By Zergnet

Comments

You May Also Like

  • The Best Way to Cut Rubber Stall Mats

    Most stall mat manufacturers will provide you with cutting and installation procedures when you purchase mats. If you're trimming down mats to...

  • How to Cut Foam Rubber

    There are several different ways to cut foam rubber. The method you choose depends on the thickness of the foam rubber and...

  • How to Cut Rubber Tires

    Old car and truck tires make a sturdy material for a variety of uses. Sandals, playground climbers and garden planters are three...

  • How to Cut Rubber Mats

    Cutting rubber mats requires precision, attention to detail and the right knife with a sharp blade. Cutting rubber can be tough, and...

  • How to Make Your Own Rubber Clothing

    Stretch your fashion imagination and create latex rubber clothing. Although textile mills are creating many materials from recycled rubber, non-latex rubbers can...

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!