Hanging a hook on a concrete block wall may seem impossible, but this job is actually relatively easy and straightforward. Drilling through the concrete does require some special tools, which are readily available for purchase at your local hardware store. If you do not want to purchase the tools, ask the store if they are available for rental.
Things You'll Need
- Hammer drill
- Masonry bit
Hold the hook on the concrete block wall. Place a mark on the wall at the screw holes' locations with a pencil. Set the hook aside.
Drill a pilot hole through each mark, using a hammer drill with a masonry bit. Use a masonry bit with the same diameter as the sleeve anchors. Drill the hole a little deeper than the sleeve's length.
Unscrew the mounting screws from the sleeves. Push the sleeves into the pilot hole. Gently tap them in with a hammer until they are flush against the wall.
Put the screw through the hook's screw holes. Line up the screws with the sleeves. Use a screwdriver to tighten the screw into the sleeve.
What Does a Concrete Block Weigh?
Constructing buildings can be a long and expensive process. Contractors constantly look for ways to save money, materials and time. Concrete blocks...
How to Hang Pictures on a Concrete Block Wall Without Using a Drill
Decorating concrete block walls with pictures isn't as difficult as it might seem thanks to a variety of products and solutions that...
How to Put Screw Hooks in the Ceiling
If you want to hang something from a wall or ceiling but need some extra support that a standard screw or nail...
How to Install a Cabinet on a Concrete Block Wall
Installing a cabinet on a concrete block wall can be a difficult process. Locating the proper spaces to drill into the wall...