Two-piece cue racks are an inexpensive means of storing pool cues. They are made out of a minimal supply of materials and function in a similar manner to most other cue racks. The bottom piece of the rack has divots that provide a resting place for the back end of the pool cue, and the top piece has either holes for the striking end of the cue to slide through or clamps for it to fit into.
Things You'll Need
- Stud finder
- Tape measure
- Two-piece cue rack, with screws
- Screw gun
Locate studs in the wall with the stud finder. Draw an “X” over each stud. Hold the rack horizontally against the wall to know if you need to mark more than two studs.
Position the bottom piece of the cue rack against the wall, using the level to make sure it is horizontal. The bottom piece of the cue rack should be no more than 30 inches above the floor. If it is too high, the ceiling may end up with chalk marks from the cues.
Screw the bottom cue rack piece to the wall. Double check with the level to make sure it's horizontal.
Measure the length of a pool cue. Subtract 8 inches from that measurement and position the top piece of the cue rack at that height above the bottom piece. Use the level to make sure it is horizontal as well as directly above the bottom piece. Hold the level perpendicular to the ends of both rack pieces. This helps ensure the top piece is directly over the bottom and also ensures the cues are held vertically. Screw the top piece to the wall at this position.
- "Step by Step Basic Carpentry"; Ben Allen
- Photo Credit Jupiterimages/Photos.com/Getty Images
How to Make a Pool Cue Rack
Having a game room in your house is nice. If you own a pool table, then you're aware of all the accessories...