Rectifier diodes will only conduct electrical current in one direction. This characteristic allows diodes to convert AC electrical energy into DC electrical energy. However, it can also prevent DC current from reversing direction.
Diodes are often used in conjunction with solar cells to prevent backfeed DC current. When a solar cell is deprived of light, it no longer generates DC power. Without a diode wired in series with the solar cell, a battery that is connected to the solar cell will backfeed electrical current into the cell and overheat the solar cell.
Things You'll Need
- Electrical pliers
- Electrical wire
- Rectifier diode designed for use in 12-volt DC circuit
- Electronic solder
- Soldering iron
- Solder-type ring terminals (2)
- 12-volt battery with L-type terminals
- 12-volt solar panel
- Machine screws
- Machine nuts
- Adjustable wrench
Cut two lengths of electrical wire at least 6 inches long. Strip ½ inch of insulation from the ends of each wire segment.
Twist together one end of the first wire with the cathode lead from the diode. The cathode lead is specified on the diode case with a line or dot near the cathode lead wire.
Use the soldering iron to melt a small drop of solder to the twisted wire joint created between the diode and the first wire. Use the tip to smooth the soldered joint until it is shiny and free of lumps.
Place a ring terminal over the loose end of the first wire. Solder the terminal to the wire.
Place the remaining ring terminal over one end of the second wire, and solder the wire to the terminal.
Attach the diode's anode lead to the "+" terminal on the solar panel. Attach the unoccupied end of the second wire to the "-" terminal on the solar panel.
Place a screw through the hole in the ring terminal attached to the first wire. Place this screw through the positive battery terminal, and screw on the first machine nut. Tighten the machine nut until it holds the ring terminal snugly against the battery terminal.
Place the remaining screw through the hole in the ring terminal attached to the second wire. Place this screw through the negative battery terminal, and screw on the second machine nut. Tighten the machine nut until it holds the ring terminal snugly against the battery terminal.
- Photo Credit Thomas Northcut/Photodisc/Getty Images
What Is a Blocking Diode?
A blocking diode is a device that controls current flows inside of photovoltaic systems. It is one way that valves are used...
How to Use a Diode in a Circuit
Think of a diode as a one-way electronic valve for electricity. When the diode is in forward bias, the diode allows current...
How to Reduce Voltage on 12 Volt System to 4 Volt
Two ways to reduce a 12-volt system to 4 volts are to use voltage dividers or Zener diodes. Voltage dividers are made...
How to Make a 12-Volt Voltage Regulator
While prepackaged devices exist to regulate low DC fixed voltages, it's possible to build your own from scratch. Zener diodes make good...
How to Back Feed a Power Generator
Some people decide to back feed an emergency generator to respond to temporary power outages. If you are familiar enough with electrical...
How to Install a Blocking Diode
Blocking diodes are one-way valves used in electrical circuits. When building your own wind dynamo chargers or solar power systems to charge...
How to Install a Backfeed Breaker
The National Electrical Code requires transfer switches or backfeed breakers with a mechanical interlock for auxiliary generators that can connect to the...