Most homes use copper piping in their plumbing systems, built up from multiple sections of pipe. If you develop a leak in a copper pipe, it usually is possible to replace just the piece of pipe that is leaking and leave the sound plumbing around it intact. Soldered joints in copper plumbing may look permanent, but with some basic tools they can be disassembled and repaired relatively easily.
Things You'll Need
- Safety goggles/glasses
- Leather safety gloves
- Pipe cutter or fine-toothed hacksaw
- Locking pliers
- Propane torch
- Old rags
- Emery cloth
Turn off the water supply at the source and open all the faucets in your house. Allow the system to completely drain all the water out.
Cut out the leaking section of pipe roughly six inches from where it enters the joints at each end. Wear safety goggles and gloves to do this.
Clamp a pair of locking pliers onto the piece of pipe that is still attached to one of the joints.
Gently begin to heat the joint with a propane torch; you are aiming to heat the joint evenly and soften the solder without overheating the copper pipe. If the joint starts to discolor stop applying heat and wait until it cools before continuing heating.
Start trying to twist the pipe using the pliers as soon as you see the solder start to melt and flow; continue to apply gentle heat as you do this. Pull hard on the pipe while continuously twisting back and forth and it will eventually come free from the joint.
Wipe the remaining joint inside and out with an old rag as soon as the damaged pipe is removed. This must be done before the joint has chance to cool and the remaining solder re-harden.
Repeat steps three through six to remove the other end of the damaged pipe from its joint. Use emery cloth to thoroughly clean the joints and make them ready to accept a replacement section of pipe.
Tips & Warnings
- Use extreme caution when using a propane torch.
- Always wear appropriate safety equipment while cutting and heating pipework.
- Photo Credit Jupiterimages/Photos.com/Getty Images
- How Long Should Copper Water Pipes Last?
Can You Paint Copper Plumbing?
You can paint copper plumbing as long as you employ the proper preparation techniques. Copper is a nonporous, durable surface that is...
How to Solder copper pipes
How to solder copper pipes - a straightforward explanation
How to Repair and Prevent Air Conditioning Pipes from Freezing
The hot summer months are very taxing for even the newest air conditioning system and if it is not properly maintained it...
How to Seal Pinhole Leaks in Copper Water Pipes
Even the smallest of leaks in a copper pipe can cause water damage to your home. Whether it's simply rusting the pipe...
How to Silver-Solder Copper Pipe
Large plumbing jobs require a great deal of knowledge and experience to complete properly. But for such small jobs as replacing a...
How to Repair a Leaky Copper Water Pipe Elbow
Repairing a leaky copper water pipe elbow generally involves removing and replacing the leaky elbow fitting. For one reason or another, the...
How to Unsolder a Circuit Board
Desoldering, the process of removing unwanted solder from metal, is an essential skill for both metal-working and electronics projects. A part might...
How to Repair a Leaking Joint in a Copper Water Pipe
Copper water pipes are connected together with couplings and elbows. The two pipes are inserted into either end of the coupling or...
How to Unsweat a Pipe
Plumbers join copper pipe with a torch and soldering paste in a process called sweating pipe. The plumber applies the solder to...
Bubbling Sound in Plumbing Pipes
It's not uncommon for plumbing pipes to make rushing or clanking sounds, but gurgling or bubbling sounds may indicate that your plumbing...