Zeno Mini Instructions
Pimples don't always appear at the right time. With Zeno Mini, you can attack your pimples on the go. The Zeno Mini is an electronic device that uses a built-in computer to control how much treatment and energy is allocated to zapping each pimple. The Zeno Mini offers a specific number of treatment cycles and each treatment lasts two and a half minutes. The Zeno Mini produces sounds and illuminates to indicate where it is in the treatment process.
Instructions
-
-
1
Pull off the Zeno Mini's top cover with your hand.
-
2
Press and hold the "Power" button for three seconds. A three-tone sound will go off, and both the Treatment Tip Life Indicator and Battery Life Indicator lights on the front of the Zeno Mini will glow. Once the "Power" button turns green, it is ready.
-
-
3
Press the "Power" button to initiate a treatment cycle. The button will flash green during this process.
-
4
Place the "Treatment Tip" on the Zeno Mini on the surface of the pimple; avoid pushing it hard into the skin.
-
5
Listen for the single-tone Treatment Pacer to sound off every 30 seconds. You will hear four single-tones by the end of the treatment cycle. A five-tone descending Treatment Complete sound indicates when treatment is complete. The power button will also turn amber at the end of the cycle.
-
6
Remove the Zeno Mini from the pimple. Wait at least 10 seconds before pressing the power button again to treat another pimple.
-
1
Tips & Warnings
The skin may appear red, the redness should disappear within a few hours.
If the battery light glows amber for one second and then turns off, there is insufficient battery life. To change the batteries, remove the bottom cover from the Zeno Mini and replace the two alkaline batteries in the battery bay on the back side of the device.
