Patio doors come in a variety of construction materials, such as vinyl or glass or wire mesh, but they all share a metal aluminum frame. To drill a hole through a patio door, for example, to run an antenna wire through from the outdoors into the home, use a power drill with a metal drill bit. The procedure is straightforward and will not affect the door's operation. You will need household tools and supplies.
Things You'll Need
- Paper towels
- Power drill, metal drill bit
- Work gloves
- Protective eye gear
Decide on the section of the patio door's metal frame where you want to drill the hole: on a bottom edge or on the side where you grip the door to open it. Measure the width of the door's metal frame to determine how big the diameter of the drill bit should be.
Place the metal drill bit into the opening in the end of the power drill. Close the opening with the locking tool on the drill.
Wipe off the section of the door's frame where you will be drilling with a water-moistened paper towel to remove loose dirt and contaminants.
Close the patio door. Slide the locking lever or turn the locking latch to keep the door closed. Plug in the power drill and on work gloves and protective eye gear.
Press the trigger on the power drill. Place the rotating drill bit against the metal frame on the patio door at the point where you want the hole to be. Push the drill bit through the frame. Pull the drill bit halfway out of the hole once the it has been pushed through. Push the drill bit back through the hole. Repeat this two more times before pulling the drill bit out of the hole.
Release the power drill's trigger. Unplug and remove the drill. Unlock the patio door and open it.
Clean the loose metal dust from the frame on both sides of the patio door -- use a water-moistened paper towel for this. Clean the floor on both sides of the door underneath where you made the holes.
Tips & Warnings
- Keep children and pets away from the patio door while you are drilling the hole.
How to Drill a Hole in a Glass Bottle
Glass usually breaks when you apply pressure from a drill, but this can be remedied with proper lubrication, gentle pressure and patience....
How to Install a Lock on a Patio Door
A patio door offers home intruders an easy entrance into your home. These doors are usually made of glass and provide access...
How to Install a Metal Door Frame Into a New Masonry Wall Opening
In masonry walls, metal door frames are often used in place of traditional wooden ones. They are made from sheets of steel...
How to Drill Through a Door Lock
If you are going to remove a door lock to replace the cylinder you will need the key to remove the cylinder....
How to Drill Through Aluminum Soffit for Wire Installation
You need to exercise care when drilling through aluminum soffit. The thin aluminum can easily tear if the drill bit catches an...
How to Repair Sliding Patio Doors
Repairing a sliding patio door is not difficult unless broken glass is involved, and even then the hardest part of the job...
How to Cut a Hole for a Patio Umbrella
Patio umbrellas require you to cut an accurately-sized hole in the patio table to ensure the umbrella's stability. If the hole is...
How to Drill Weep Holes in Walls
Many masonry walls consist of fascia bricks placed over a cement or plywood base. If water leaks in between the base and...