How to Default a DSC Alarm Panel

Save

DSC is a brand of a home alarm system owned by Tyco International, a Swiss-American manufacturing company. Various settings and alarm codes are programmed into your alarm system during setup, including the master unlock code and several access codes for members of your family. Defaulting your DSC alarm panel returns the system to its factory settings so you can reprogram the alarm from scratch. There are two ways of defaulting your DSC alarm: shorting out the hardware or using an installer code via the system's software.

Things You'll Need

  • Short strip of conductive wire

Hardware Default

  • Disconnect the AC power cable and battery from the alarm panel. There should be no power reaching the alarm.

  • Pull the wires out of the Zone 1 and PGM terminals.

  • Connect the Zone 1 and PGM terminals together with a short piece of wire for a few seconds.

  • Reconnect the AC power supply to the alarm panel and wait for the Zone 1 light to glow.

  • Disconnect the AC power and replace the battery. Reconnect the wires to the Zone 1 and PGM 1 terminals and plug the alarm panel back in. The system default is complete.

Software Default

  • Touch the "asterisk" button then "8" on the front of the alarm panel. The system will enter Installer Programming mode.

  • Press the "9" button three times and enter the system's installer code. The default installer code is "5010," but you may have changed it when the system was installed.

  • Press "9" three more times to confirm the default. The system will take a few seconds to return to the factory settings.

References

Promoted By Zergnet

Comments

You May Also Like

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!