How to Change the EGR Valve on a Chevy Impala

by Leonardo R. Grabkowski
itstillruns article image
http://commons.wikimedia.org, http://www.flickr.com/photos/1962_cb77_restore/, http://www.flickr.com/photos/samuraiaz/

The Chevrolet Impala uses a EGR (Exhaust Gas Recirculation) valve to monitor and reduce the flow of harmful tailpipe emissions. Faulty EGR valves can result in check engine lights, poor fuel economy and rough idling. Take care of your faulty EGR valve as soon as possible

Step 1

itstillruns article image

Locate the Impala's EGR valve. The EGR valve is located on the driver's side of the engine bay towards the rear, regardless of whether the vehicle is equipped with the 3.4 or the 3.8-liter engine.

Step 2

itstillruns article image

Use the pliers to remove the rubber tubes connected to the EGR valve. There will be one tube in the rear and one in the front. Be careful not do damage the tubing when you are sliding it off.

Step 3

itstillruns article image

Use the socket wrench to remove the two bolts connected to the base of the EGR valve. If you feel a strong resistance, you may want to spray some anti-seizing compound on the bolts to help loosen them.

Step 4

itstillruns article image

Remove the EGR valve and the gasket from the mount. Once the valve is removed, the gasket should slide right off. Set the items aside.

Step 5

Place the new gasket over the mount, and then place the new EGR valve on top of it. Make sure they are properly lined up. Re-install the bolts and connect the tubing.

More Articles

article divider
×