A charcoal filter resides inside of the charcoal filter canister in an automobile. The main purpose of the charcoal filter and the charcoal canister is to absorb excess gas fumes from the fuel system and the gas tank while the engine is off. The filter inside of the canister acts like a sponge and absorbs all of the excess gas fumes. Once the engine is restarted, the excess gas vapors return to the fuel system and into the combustion chamber. Over time, excess buildup can clog up the charcoal canister and prevent the gas fumes from entering or exiting the canister.
Things You'll Need
- 3/8-inch drive socket set with ratchet
- Flat head screwdriver set
- Air compressor with air line
- Quick connect air line nozzle with rubber tip
Remove the charcoal canister by removing the top and bottom lines from the canister with a flat-head screwdriver. The canister has three lines on top and one line on the bottom. Use a ratchet and a socket if needed to remove the canister from the bracket.
Place the charcoal canister on a flat surface. Start the air compressor up and let the air pressure build up to at least 50 psi. Shut the compressor off once the air pressure reaches the 50 mark.
Insert the rubber tip of the air line nozzle fitting into the outer vent control valve pipe that is on top of the canister. This pipe is separate from the other two top pipes. The outer control pipe is the on the very end of the canister. The outer control pipe is also a little bit bigger than the other two pipes.
Place the ends of your fingers over the openings of the other two pipes on top of the canister with one hand. Pull the air release trigger on the air line nozzle and allow the 50 psi of air to blow into the canister with the other hand. Continue blowing the air into the charcoal canister for about one to two minutes. Remove your fingers from the top pipes and place one of your fingers near the front opening of the pipe on the bottom of the canister.
Apply the air to the opening of the control valve pipe again and use your finger to determine if the air is coming out of the bottom of the pipe. This will ensure that the canister is clean and allowing air flow from the top of the canister to the bottom pipe of the canister. Reinstall the charcoal canister.
Tips & Warnings
- The manual calls for anywhere between 40 and 50 p.s.i of air pressure.
- You can find a air blower nozzle at most any auto parts store or hardware store.
- Never wash the inside of the charcoal canister with any type of liquids. Only use 40-50 p.s.i of compressed air to clean the charcoal canister.
- Wear safety glasses when using compressed air.
- " Toyota Tacoma Haynes Repair Manual covering 2005 thru 2009 models;" John Haynes; 2010
- IH8Mud: Charcoal Canister test procedure
The Purpose of a Charcoal Canister
The importance of controlling emissions from automobiles created the need for a refined and modified automobile system. The charcoal canister was developed...
Danger of a Faulty Purge Valve
The purge valve is part of the EVAP (evaporative emission control) system of the automotive gasoline engine. The EVAP system prevents gases...
How to Test Evaporative Charcoal Canisters
Each gasoline fuel-burning vehicle on the road produces fumes from combustion processes within the engine. Car manufacturers have devised an internal vehicle...
How to Remove a Charcoal Canister
The charcoal canister on a vehicle is attached to the gas tank via a series of hoses, and is designed to catch...
How to Replace a 2002 Toyota Camry Charcoal Canister
The 2002 Toyota Camry uses an evaporative emissions control system (EVAP) to catch fuel vapor and reroute them to the engine when...
How to Replace an Evaporator Canister in a 2000 Silverado
The evaporator (EVAP) canister on a Chevrolet Silverado is part of the fuel-evaporative-emissions-control system. The canister is filled with activated charcoal, and...
Location of the Ford Taurus Canister Purge Control Valve
The Ford Taurus canister purge control valve is a part of the evaporative emission control system, which keeps fuel vapors from escaping...
How to Vent My Gas Tank
Beginning with the 1970 model year, automobiles have used charcoal canisters to filter out pollutants from the fuel system so that they...
How to Replace a Vapor Canister on a 2000 Toyota Echo
Your 2001 Toyota Echo came equipped with a vapor canister that is used to control fuel emissions from your exhaust system. The...
How to Put on Toyota Charcoal Canister Parts
The charcoal canister on Toyota cars and trucks is an emission control device that is meant to trap excess gasoline vapors from...
Symptoms of a Bad Purge Valve
The purge valve is part of your car's evaporative emissions system, which captures any fumes from the fuel tank before they can...