How to Make a Water Ski Pole

Save

On rare occasions, the pylon in your ski boat can become warped, or may need replacements along with the floor boards. The United States Water Ski Association has strict sizing requirements for ski pylons, and they must be able to withstand extremely heavy loads. It is very important that the pylon be precisely centered in the boat so that it does not give the skier an advantage on one side of the course and must be able to accommodate the rope swinging from side to side.

Things You'll Need

  • Measuring tape
  • Marking pencil
  • Hacksaw
  • Grinding tool
  • Medium file
  • Fine file
  • 48 inch brushed stainless steel pole, 2 1/2 inches in diameter
  • 4 inch brushed stainless steel pole, 3/4 inch in diameter
  • Drill and drill bits
  • Gas welder
  • Safety goggles
  • Welding apron and gloves
  • Mounting screws
  • Measure the height of the engine cover from the water line when there are no people in your boat. Your ski pylon must be between 65 cm and 120 cm from the waterline, per USAWS specifications and must clear the engine cover. Remove the floorboards and cut the steel pole to length.

  • Slide the pipe into the mounting base and mark the locations of the mounting holes on the pipe with a marking pencil. Drill holes through the pipe at these locations.

  • Taper the top of the steel pipe with a grinding tool so that the pole tapers to a diameter of 1 1/2 inches, 3 inches below the top of the pipe. Drill a hole through the side of the pipe 4 inches below the top of the pole with a 3/4-inch drill bit, making sure it is facing side to side when the mounting holes line up with the base. Tough up the rough steel with a medium file, then a fine file.

  • Slide a 3/4-inch pole through the drilled hole at the top of the pylon and make sure it is centered. Put on your safety goggles, gloves and welding apron and weld the pole to the pylon.

  • Slide the pylon into the base plate, secure it with mounting screws and replace the floor boards.

Related Searches

References

  • Photo Credit Jupiterimages/Comstock/Getty Images
Promoted By Zergnet

Comments

You May Also Like

  • How to Make and Use a Shot Ski

    Cutting the cake, tossing the bridal bouquet and raising a toast to the bride and groom are timeless wedding traditions. Create a...

  • How to Drill through Stainless Steel

    Drilling through stainless steel is not impossible, even though it may seem like it. Stainless steel's chromium content makes it more difficult...

  • How to Build Your Own Ski Pylon

    Other than the boat, the skis, the rope and a lake to ride on, the other most important piece of ski equipment...

  • How to Measure for Downhill Ski Length

    Buying downhill skis isn't as simple as walking into the store and asking for a couple of fiberglass planks for your feet....

  • How to Make Concrete Pylons

    Concrete pylons are used for various functions. Concrete pylons or pillars are used as support structures. A good, strong concrete mix and...

Related Searches

Check It Out

How To Travel For Free With Reward Points

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!