How to Put a Belt on a Caterpillar C12


Replacing the drive belt on a Caterpillar C-12 is a necessry maintenance task to ensure the engine is running smoothly at all times. The belt transmits power from the crankshaft to the components located on the front of the engine. Once the belt has become frayed, torn or broken, it will require immediate replacement.

Things You'll Need

  • Socket wrench
  • Socket set
  • Open the hood for access to the engine compartment. Ensure the truck is turned off and the key is out of the ignition.

  • Locate the tensioner pulley at the top passenger side of the engine. The tensioner is located below the alternator.

  • Loosen the tensioner pulley with a socket wrench by pushing the arm on the tensioner down to loosen the old belt.

  • Take the belt off the pulley. Replace the old belt with the new belt. Locate the belt routing diagram to ensure the belt is routed correctly.

  • Push the belt tensioner down with the socket wrench. Place the belt over the tensioner pulley to place tension on the belt. Release the tensioner to tighten the belt.

  • Start the truck and allow it to idle. Watch the belt to ensure it runs over the pulleys smoothly.

Tips & Warnings

  • Use caution working under the hood of the truck. Ensure the truck is turned off and the key is out of the ignition.

Related Searches


  • "Caterpillar C10 12 15 16 Repair Manual Caterpillar Part Number SENR 9576-02"; Caterpillar; 2002
  • Photo Credit Jupiterimages/ Images
Promoted By Zergnet


You May Also Like

Related Searches

Check It Out

How To Travel For Free With Reward Points

Is DIY in your DNA? Become part of our maker community.
Submit Your Work!