Caulking the expansion joint surrounding your concrete pool is an important part of pool maintenance to avoid future cracking of the pool edge or an adjacent deck surface. The expansion joint prevents the pool and deck from constantly banging together due to expansion of materials during the freeze/thaw cycle in the winter or sifting soil beneath the two structures. Without an elastomeric sealant between the two surfaces, contact can occur, leading to anything from a cracked pool tile to cracks in the concrete or deck itself. The sealant is easy to apply, however, so there's no need to have the pool contractor back for an expensive visit.
Things You'll Need
- Nylon brush
- Mild liquid soap
- Backer rod foam
- Utility knife
- Masking tape
- Elastomeric sealant
- Caulking gun
Clean out the expansion joint between the pool and the deck, using a nylon brush to remove any dirt or debris from within. Wash the inside of the joint with a mix of mild liquid soap and warm water, using the brush. While washing inside the joint, wash the two surfaces to either side with a sponge as well, extending from the joint edge about 4 inches. Rinse off the soap with clean water, and then pat the surface dry with a clean rag.
Measure the depth of the expansion joint, using a ruler, and then subtract ½ inch from the measurement. Purchase backer rod foam from a hardware or home improvement store with the same diameter as the modified depth measurement.
Stuff the backer rod foam into the expansion joint, pushing it to the bottom of the joint with the end of a flat-head screwdriver all along the perimeter of the pool. When in place, the foam should leave a space of about 1/2 inch in the expansion joint for adding the caulk. Cut the rod when necessary with a utility knife.
Place strips of masking tape along the surface of the deck and the pool on both sides of the joint. The tape will prevent the caulk from overflowing the joint area and will help you create a sharp caulk line.
Use an elastomeric sealant to caulk the joint. Pack the joint full to the surface with the sealant, using a trowel or caulking gun to press the sealant firmly into the joint over the foam rod. Go over the surface of the caulk with the flat of the trowel to level it out on the surface of the pool. It's fine if the caulk goes onto the masking tape bordering the joint.
Pull the masking tape from the sides of the expansion joint to create sharp edges to the caulking. Allow the caulk to dry for the length of time suggested by the caulk manufacturer before using the pool area.
Tips & Warnings
- Wait 30 days after your pool is poured before you fill the expansion joint.
- Photo Credit Brand X Pictures/Brand X Pictures/Getty Images
How to Repair a Pool Expansion Joint
An expansion joint is between the pool itself and your deck and repairing a pool expansion joint yourself can save you a...
How to Clean Pool Coping
Swimming pool coping forms the overhanging edge of a pool that blends into the concrete. Coping receives heavy use as a resting...
How to Seal a Tile Pool
Pools are a great outdoor attraction, providing both beauty and amusement for the entire family. Most tiles used in a pool are...
How to Caulk a Pool
The space between the pool coping and pool deck requires caulk to prevent water from going behind the coping and eroding the...
How to Recaulk the Pool Coping
Tiles add a decorative edge around the perimeter of the swimming pool. As the pool coping, these tiles rest on top of...
How to Replace the Caulking in a Swimming Pool
An in-ground pool usually has an expansion joint where the pool deck meets the coping stones at the edge of the pool....
How to Fill in or Grout Cracks Between Pool Deck & Coping
Cracks can develop between the pool deck and coping for a number of reasons, from shifting soil to failed expansion joints. Whatever...
Types of Caulk for Concrete
From filling in joints on a driveway to repairing a hole in a wall, there are a number of reasons why you...