Losing a stone from a piece of jewelry can be quite distressing. Fortunately you can repair most pieces at home if you find the stone. Gold and silver are easier to work with because of their soft nature. This nature makes repair work easy enough to accomplish with minimal tools. You do not need any special tools or experience to fix your broken jewelry.
Things You'll Need
- Dish detergent
- Small flat-headed screwdriver
- Small leather scrap
- Super glue
- Soft cloth
- Polishing compound
Brush the setting and stone with a soft bristle toothbrush and a little dish soap in warm water to remove accumulated oil and dirt. Add the dish soap to warm water and brush the stone and setting, dipping it into the soapy water between scrubbing, until the stone and setting are clean. Rinse with warm water. An ultrasonic jewelry cleaner also does this job well, if you have one. Follow the manufacturer's directions to clean your stone and setting.
Examine the setting closely to determine how the stone fell out. Most commonly, the stone catches its edge on something and pulls free of the setting. Occasionally however, one of the prongs can break off of the setting itself. Broken prongs require professional repair.
Use a small flat-headed screwdriver with a scrap of thin leather over the end to coax the setting's prongs open. The leather prevents the hard steel in the screwdriver from marring the setting. Properly opened prongs just barely allow the stone into or out of the setting.
Set your stone back into its setting. Apply a bare minimum dab of super glue to the stone where it meets a post to hold it in place when tightening the prongs again. Too much glue will show and ruin the appearance. You only need enough to hold the stone in place temporarily. The intent is not to hold the stone with glue alone but to assist you in holding it still.
Push the prongs down onto the stone using the screw driver and leather. Do not over tighten the prongs, only press them down until they touch the surface of the stone. Tighten opposite sides as you move around the stone to keep the pressure even.
Polish your jewelry to remove any smudges or scratches you may have made on the piece during the repair process. Use a soft cloth and a commercial polishing compound to restore a brilliant shine.
- Photo Credit Jupiterimages/Goodshoot/Getty Images
How to Fix a Broken Exhaust Pipe
You don't want to drive with a rusted-through exhaust pipe dragging noisily on the road. Before you get to the muffler shop,...
How to Oil Emeralds
Natural emeralds are riddled with fissures and cracks before treatment. Some are also slightly cloudy or opaque in patches due to the...
How to Measure a Gemstone
Maybe you're a jeweler at a local jewelry store and need to measure a loose gemstone. Or perhaps you're looking at making...