The Echo GT 200R string trimmer comes with a fixed line system, which means, unlike other trimmers, it uses a single, short piece of nylon line. This nylon is thicker than regular lines and will break off less frequently against hard surfaces, like rocks, or curbs. However, since this line is larger than most, you will need to replace the line with only the same type and size of line, as recommended by Echo's manufacture guidelines.
Things You'll Need
- 8-inch piece of .08-inch diameter line, 2
Slide the ignition switch on the rear handle into the "Off" setting to shut off the Echo GT 200R's engine. Place the engine onto the ground, positioning the head so it's upside down. Wait until the head stops spinning before grabbing it.
Grab the moving part of the head and pull out both pieces of nylon line through the recesses in the center head. Clean the area around the recesses, the outer wall of the head, and inside the head with the rag. Look for cracks, chips and other signs of head damage and replace immediately if broken.
Push the new .08-inch diameter trimmer line through the hole on the outside of the head. Push the second piece of line through the opposite hole on the outside of the head. Push the lines through until they meet in the middle. Line lengths should be equal proportions.
How to Replace a Line on an Echo Gas Trimmer
Echo gas trimmers employ a Rapid Loader™ 2-line head, which allows for quick line changes that require no tools. Pre-cut lengths of...
How to Adjust the Carburetor on an Echo Line Trimmer
When the gas and air flow through the carburetor, they need to have the precise mixture. Otherwise your engine on your Echo...
How to Replace the Line on an Echo SRM-2100 Trimmer
The Echo brand SRM-2100 trimmer/brush cutter is a professional-grade tool designed for outdoor use. The trimmer uses a nylon line spinning at...