How to Reset a Kawasaki Prairie Belt Switch

Save

An illuminated belt light on your Kawasaki Prairie's instrument panel is usually an indication that the ATV's belt is ready for replacement or adjustment. But, once the belt is taken care off, the light has a habit of sticking around. Many Prairie owners opt to deal with the problem by riding with the light on, since there is no visible way of resetting the light. Doing so is dangerous, however, as the light will not be able to warn you of potential belt problems. Luckily, resetting the light is a quick task that can put an end to your frustration.

  • Park your Prairie on a level surface and turn the ignition to the Off position. Let your Prairie cool for at least 15 minutes.

  • Follow the belt failure sensor's wiring from the rectangular box above the CVT belt cover on the right side of the motor to your Prairie's wiring harness. Unplug the wiring's 2-pin connector from the harness.

  • Unplug the gray and black wiring connectors, located above the CVT belt cover. Plug the male gray connector into the female black connector and the male black connector into the female gray connector.

  • Turn your Prairie's ignition switch to the On position. The belt light will begin to flash. Turn the ignition switch to the Off position after 10 seconds.

  • Unplug the gray and black connectors and reconnect them to their corresponding connectors. Reconnect the belt failure sensor's 2-pin connector to your Prairie's wiring harness.

Related Searches

References

  • "The Professional Motorcycle Repair Program"; Professional Career Development Institute; 1995
  • "Kawasaki KVF650 4X4 All Terrain Vehicle Service Manual"; Kawasaki Heavy Industries; 2004
Promoted By Zergnet

Comments

You May Also Like

Related Searches

Check It Out

How To Travel For Free With Reward Points

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!