How to Put Speakers in a Gaming Chair
Having a special gaming chair can help put you in the action of your favorite video games. Most gaming chairs allow you to place the chair in the best spot to play and allow you to connect the sound from your console to speakers inside of the chair. If you do not have speakers in your chair, or are looking to replace them, you can install them and connect them to your console in a few steps.
Other People Are Reading
Instructions
-
-
1
Place the gaming chair on the ground in front of you with the back facing upwards. Find the screws that hold the back onto the chair. Use the Phillips screwdriver to remove each of these screws and place them to the side to replace when you are finished.
-
2
Remove the back of the gaming chair to gain access to the internal parts. Locate the speakers you want to remove and replace if there are any. Cut the wires coming from these speakers with the wire strippers. Use the screwdriver to remove the screws holding the speakers in place and pull the speakers out of the openings. If you are installing speakers where there were none, move to Step 3.
-
-
3
Place the speakers you want to install into the speaker openings in the chair with the front facing out and the back inside the chair. Insert the screws into the holes on the speaker and use the Phillips screwdriver to secure the speakers.
-
4
Run the speaker wires coming from the control panel in the chair to the speakers. Use the wire strippers to expose the ends of these wires and the wires from the speakers and splice them together but inserting both ends into a wire connector.
-
5
Replace the back on the gaming chair and use the screwdriver to reinsert the screws that were holding the back in place. Connect the power cord from your chair into an open wall outlet, and connect the audio cables from your console into the ports on the control panel.
-
1
Tips & Warnings
Depending on the model of gaming chair you are using, you may need to use a different type of screwdriver to remove the screws. Look at the heads of the screws and use an appropriate screwdriver.
