Spider cracks are a form of fiberglass damage that occurs from minor flexing or impacts. They can occur in any form of fiberglass, including cars, boats and swimming pools. Small cracks form in the outer surface of the fiberglass, spreading out from a central point like a spiderweb. These cracks do not affect the structural integrity of the fiberglass, but are an aesthetic issue. Fortunately, spider cracks are not difficult to repair.
Things You'll Need
- Electric sander (optional)
- Masking tape
- Plastic sheeting
- Paper bucket
- Mixing stick
- Polyvinyl Alcohol
- Spray gun
- Soapy water and sponge
- Primer and paint (optional)
Clean the area with acetone and a rag to remove any dirt or other impurities.
Sand the damaged area with 100-grit sandpaper to roughen the surface. You can sand by hand or with an electric sander.
Wash the area with acetone a second time to remove all sanding dust.
Mask off the area around the cracks with masking tape and plaster to protect against drips.
Pull all of the loose bristles out of a cheap paint brush. Loose bristles may become embedded in the gelcoat.
Measure a small amount of gelcoat, which is a thick form of fiberglass resin, into a paper bucket. If the fiberglass will be exposed to water, the gelcoat should be marine grade.
Mix catalyst into the gelcoat following the instructions on the container. Precision is important: if you add too much catalyst the gelcoat will cure faster than it can be used, but if you add too little it won't cure at all.
Brush a thin layer of gelcoat onto the sanded area, feathering it out a bit onto the surrounding fiberglass surface.
Allow the gelcoat to sit for three hours, then spray it lightly with Polyvinal Alcohol to help it fully cure.
Allow the gelcoat to cure for 24 hours.
Wash the Polyvinal Alcohol off with soapy water.
Sand the area with 300-grit sandpaper to begin smoothing it. Re-sand it with 600-grit, then 900-grit and so on. Keep jumping 300 grit at a time until the repeated sanding has produced as smooth of a finish as you require.
Clean off the sanding dust with acetone.
Prime and paint the fiberglass to match the surrounding surface if needed.
Tips & Warnings
- Wear rubber gloves when working with gelcoat.
- Work in a well-ventilated area.
- Photo Credit Jupiterimages/Photos.com/Getty Images
How to Repair Fiberglass Cracks in Autos
Many car parts are made of fiberglass, and it is common for fiberglass parts to crack. Taking your vehicle into a body...
How to Fix Cracks in Fiberglass Sinks
Fiberglass sinks are durable but can become cracked or fractured over time. Fiberglass is easy to work with and often can be...
Gelcoat Stress Crack Repair
Gelcoat is a polyester resin-based paint used on all sorts of fiberglass, such as boats, RVs, and tanks. Gelcoat is a very...
How to Repair a Hairline Crack in Fiberglass
Fiberglass is a highly durable material consisting of many fine fibers of glass. Fiberglass is commonly used in automobile frames, surfboards, tent...
How to Fix a Fiberglass Pool Crack
Fiberglass pools are relatively hardy and, with careful use, will last for many years. However, even the most careful people can have...
What Causes Fiberglass Tubs to Crack?
Fiberglass is one of many materials used to make tubs. The lightweight, inexpensive material can be easily molded into bathtubs with a...
Spider Cracks in My New Pool Plaster
Spider cracks in a pool's plaster are common and do not always mean structural damage. Plaster cracks as it ages and dries,...