How to Wire a Vibe Evolution Sub
If you are disappointed by the level of the bass in your car then you can install a Vibe Evolution subwoofer into the back of it. Vibe Evolution subs are well regarded. It is quite simple to set up and wire a Vibe Evolution sub into the back of your car, as with most modern subwoofers.
Other People Are Reading
Instructions
-
-
1
Tape the Vibe positive power and remote turn on cables together and pass these behind the trim panels on the side of your car.
-
2
Connect the remote turn on cable behind your audio system to the Vibe cable. Connect the Vibe power cable to the power distribution block.
-
-
3
Thread the RCA cables through the trim of the car. Connect the RCA cables to the output of your audio system.
-
4
Thread the earth cable from the back of the car along the trim to the back of your power distribution block.
-
5
Connect the power, remote plug in and RCA cables into your Vibe Evolution sub. You have now wired the device.
-
1
