If an outboard motor is "missing," that means that the spark required to ignite the fuel and air mixture from the carburetor is either weak or absent altogether. This means that you are wasting one cylinder's worth of fuel with each full revolution of the motor's flywheel. Either the spark plug is damaged or no power is reaching the plug. Since you can't climb inside the cylinder and watch each spark plug in action, you must check the spark outside of the motor.
Things You'll Need
- Spark plug wrench
- Torque wrench
- Rubber glove
- Rubber mat
Ensure the spark plug wires are properly connected. Inspect the entire wire, from the plug to the magneto beneath the armature plate. Try to remove the spark plugs by hand the ensure the plugs are properly seated. Use a spark plug wrench to remove the plugs, one at a time, and tag them to identify the cylinder in which they were installed. Inspect the plugs.
Replace the spark plugs in the bores from which you removed them, if they are in satisfactory condition. Tighten them to the proper torque with a torque wrench. Hold the plug wire about 1/4 inch from the powerhead, not over the spark plug. Turn the motor over one time only, either with the recoil starter or the electrical starter.
Watch for a spark and observe its character. A good, strong spark means the air and fuel mixture in the cylinder will be ignited properly. Repeat this for each spark plug wire. If a one wire sparks well, but another does not, the system is weak; a weak spark or no spark means the magneto is at fault and should be replaced.
Tips & Warnings
- Wear a rubber glove when you preform this test -- the thicker the better -- and conduct the test while standing on a rubber mat.
- "Evinrude Repair Manual 2.5 to 250 HP Models, 2002-2007"; Seloc Marine; 2007
- Photo Credit spark image by Zbigniew Nowak from Fotolia.com
How to Change Spark Plug Wires in a Mercury Outboard
You may need to replace the spark plug wires on your boat's Mercury outboard motor as it ages. Running from the capacitor...
How to Test Spark Plugs
When you experience a sluggish engine, there's a good chance that you could have a bad spark plug. Difficulty cranking, low momentum...
How to Set an Outboard Point Gap
Setting the point gap on an outboard motor equipped with a magneto-breaker point ignition system is one of those small projects that...
How to Test Spark Plugs
When testing spark plugs, make sure that all of the fuel pressure is out of it so that fuel doesn't get dumped...
How to Troubleshoot & Repair Small Outboard Motors
Outboard motors are detachable engines that are mounted onto brackets located on the back end of a boat or on a boat's...
How to Replace a Solid State Magneto in an Outboard Marine Motor
The magneto in an outboard ignition system uses permanent magnets and pickup coils to produce AC voltage. That AC voltage gets triggered...
How to Check the Power Pack on a Johnson Outboard Motor
The power pack on your Johnson outboard boat motor is a central part of the ignition system. The power pack supplies voltage...
How to Tighten Outboard Spark Plugs to the Proper Torque
Spark plugs create a small explosion inside the motor when combined with fuel, thus engaging the pistons on your outboard motor. A...