How to Install a Glass Quarter Panel on a Chevy S-10 Blazer
Installing the glass quarter panel on the door of your Chevrolet S-10 Blazer requires disassembling your Blazer's door. The glass quarter panel is held in place to the door by a few securing bolts inside the door. To install a new glass quarter panel, remove the inner door panel and the old glass. It is a tricky process, but it should not take you more than an hour.
Other People Are Reading
Instructions
-
-
1
Open the door and pry out the armrest with a slotted screwdriver. The armrest panel is held in place by a single retaining clip. Remove the clip with a slotted screwdriver and remove the armrest panel from the door.
-
2
Remove the plastic clips securing the inner panel of the door with a slotted screwdriver. There are several clips all along the edge of the inner panel. Once the clips are removed, you can lift the inner panel from the door. Disconnect the electrical connection before removing the inner panel.
-
-
3
Loosen and remove the four corner bolts from the glass with a socket wrench. Remove the glass and install a replacement quarter panel onto your S-10.
-
4
Reattach and tighten the bolts to the glass. Reattach the inner panel to the door and reconnect its electrical connection. Reattach the armrest panel and close the door.
-
1
