If you are tired of replacing batteries in your portable radio or in any other battery-powered device, using an AC power adapter is a good alternative. All you need to do is to determine the voltage(V) and current (mAh) of the device. Then, attach the appropriate adapter to the place where the batteries make contact inside the device.
Things You'll Need
- Electrical tape
- Dowel rods (optional)
- Small wood screws (optional)
Remove and count the batteries in the device you're adapting. Standard dry-cell round batteries such as AAA, AA, C or D are all 1.5 volts. Multiply 1.5 by the number of batteries. So, four batteries would equal 6 volts; six batteries would equal 9 volts and so on.
Find the current or amp (mAh) rating either in the specification sheet in the device's manual or on a sticker on the device itself. This value is the current (mAh) for which the adapter should be rated. Using an adapter with a higher mAh value than your device is OK because the device will only use what it needs from the adapter.
Purchase an AC adapter that matches the voltage and mAh you figured out in the steps above.
Cut off the low-voltage connector at the end of the adapter's wires. Strip about a half inch of insulation from the wire's ends and pull them apart about by 4 or 5 inches.
Look into the battery compartment and notice that there are two connectors the batteries touch on either side of the compartment. One side has the two connections tied together by a piece of metal, while the other side has two separate connectors. The adapter's wires will connect to the side with the separated connections.
Identify the neutral wire of the adapter by the white stripe or raised strip on one of the wires. Attach the neutral wire (with electrical tape or solder) to the negative terminal inside the battery compartment. Remember to only attach the wire to the side of the battery compartment where the connections are not tied together.
Connect the positive wire from the adapter to the connector in the battery compartment where the nub of the battery or + normally goes. Again, only connect to the side of the battery compartment where the connections are not tied together.
Tips & Warnings
- Step two says that you should check the specification sheet or sticker of the device for the mAh rating. An alternative is to look at the mAh value on one of the batteries removed from your device and match it to the size of the adapter's current (mAh) rating.
- Check your adapter for overheating if you're not sure of your device's current (mAh) rating. If the adapter gets too hot it could burn out, so it would be a good idea to get a larger current (mAh) rated adapter.
- Photo Credit Power Pack image by Cinneman from Fotolia.com
How to Convert Battery Operated Devices to Plug-in
Today, an astonishing number of devices are battery-powered, ranging from tape recorders to cell phones and bouncy seats. While battery-powered devices offer...
How to Convert Battery Power to AC
Traveling presents a wide variety of changes to your personal lifestyle. You may have many devices you desire to use which work...
How to Replace AA Batteries With AC
For example, a device requiring 2 AA batteries uses 3 V DC. The first flat battery terminal ... How to Make Your...
How to Replace a 9-Volt Battery With an Adapter
How to Replace a 9-Volt Battery With an Adapter. ... Nine-volt AC to DC power adapter; Soldering iron; Electronic (rosin core) solder;...
How to Make Your Own AA to C Battery Adapter
In 1936, evidence of a 2,000 year old clay-pot battery was discovered near Baghdad, notes allaboutbatteries.com. It's speculated that the large battery...
How to Wire LED Lights
Wiring LED lights can be a bit tricky because of the accuracy demanded in circuit values and the number of LEDs in...
Battery Charger Vs. AC Adapter
Both battery chargers and AC adapters convert household alternating current to direct ... They also handle a restricted range of battery sizes,...