By preventing the backflow of water once the pump or water supply has been shut off, a check valve lightens the load on a water pump, prevents overspill and even guard against gray water contamination. Check valves can be one of the most important elements of a plumbing system. Because of their importance, checking and testing these valves helps ensure that the consequences of a broken check valve are never realized.
Things You'll Need
- Channel locks
- Plastic handled screwdriver
Shut off the water supply to the check valve. Follow the water line backwards (the flow of water is indicated by an arrow on the check valve) and switch off the next valve. Wait 15 to 20 minutes for the water pressure to subside.
Check the valve for debris by tapping its side with the handle of a screwdriver. A rattling sound means the check valve is fine, but inconsistent grinding or squeaking indicates that the valve is stuck on some form of debris. If the check valve is of the 90 degree (right angle) variety, remove the top of the valve (use the channel locks to turn the top of the valve to the left) and check the inside of the valve directly. There should be a dropping ball-pin on the inside, but nothing else. Replace the top of the valve.
Stand near the valve and have an assistant turn the water supply on for five seconds before quickly shutting it off again. Put your hand on the valve and place your ear near to it. If you feel or hear any water running, it is a sign that the valve's seal is leaking. Most of the time, however, you will hear and feel a gentle "click" sound as the valve closes and water will cease running through the valve as the water is shut off.
Tips & Warnings
- Check valves are designed to interrupt the flow of air or water when their system is not activated. Testing either type of valve (air or water) can be done with the same principles as above: turn the system on, then off and observe whether the valve is interrupting flow.
Ball Valve Torque Calculation
Standard ball valves are known as quarter-turn valves. The valve stem rotates a metal ball with a hole drilled in it through...
How to Test The Relief Valve On Your Hot Water Heater
All hot water heaters come with a pressure valve. Basically, this valve is there to keep your hot water heater from blowing...
How to Check an Idle Air Control Valve
The idle control valve in your vehicle is mounted on the throttle body and controls the air flow into the engine from...
How to Replace the Check Valve in a Vacuum Booster
A vacuum booster uses vacuum pressure from the engine to boost the amount of pressure going to the brakes. The check valve...
How to Install Water Pressure Gauges
Installing a water pressure gauge on your water system will help you diagnose water flow problems. There are two distinct water measuring...
Orbit Sprinkler Instructions
Orbit has been producing lawn care products for more than 40 years, and their sprinkler system line makes installing an entire sprinkler...
How do I Test a Backflow Valve?
Backflow valves, also known as check valves, allow water to flow only in one direction. When installed properly, backflow valves prevent water...
How to Test a Brake Booster Check Valve
Nearly all of today's automobiles are equipped with power-assisted brakes. The power assist system makes use of an ingenious booster that is...
How to Install a Water Flow Check Valve
Water flow check valves prevent water from flowing back into a pump. The valves are one-way, allowing the water to flow in...
How to Check the Valve for a Water Pump
Valves used in conjunction with water pumps serve a very important function. Whether they have flapper valve designs made from metal, rubber...
How to Check if a Taco Zone Valve Head Is Working?
Taco makes a range of heating and cooling products, including a Taco zone valve. The zone valve works with hot water or...
Finishing Touches to Repairing Squeaky Sink Handle
Learn the finishing touches to repairing a squeaky sink handle in this free video.