The Kuryakyn Hypercharger, available for both metric and American motorcycles, adds not only a bit of flashy chrome to the engine, but improved performance, as well. As part of installation, you may wish to re-jet your carbs to make use of the increased air flow, and if you have not already done so, a high-flow exhaust will cap the package off with a noticeable increase in power, not to mention the extra bark to go along with the bite.
Things You'll Need
- Allen wrench set
- Needle nose pliers
- 18-inch length of 3/8-inch inside diameter hose
Remove the Stock Air Cleaner and Install Vacuum Lines
Remove the stock air cleaner assembly of your motorcycle using a wrench and set aside. You may wish to box it up for the time being until you are certain that the Hypercharger will fit your needs.
Turn off the fuel cutoff switch, then remove the vacuum line from the carburetor.
Cut a two-inch length of 3/8-inch vacuum hose and attach the "t" shaped fitting supplied with the kit to the vacuum line, then reattach the spliced line to the carburetor.
Install the Kuryakyn Hypercharger
Remove the Hypercharger's round trap door using an Allen wrench, and insert three cap screws included with the kit into the mounting holes from the inside. Do not put a bolt through the bolt hole now in the 10 o'clock position.
Place the Hypercharger over the included spacer ring and support bracket, then gently tighten the bolts which hold the intake in place.
Replace the trap door and the intake gasket.
Reattach the vacuum hose into the inlet located on the back of the Hypercharger unit. Run the remaining section of hose to the breather tube on the carburetor, then to the ground. Route the line through tight places with needle nose pliers.
- Photo Credit motos image by chantal cecchetti from Fotolia.com
How to Install a Harley Hypercharger
The Kuryakyn Hypercharger is a high-flow air cleaner designed to look like a velocity stack or a supercharger. Trap doors on the...
Installation Instructions for Harley Davidson Signal Mirrors
Turn signals are considered by motorcyclists to be one of the biggest detriments to the appearance of a motorcycle and often appear...
How to Install a Supercharger
The installation of a supercharger is something you can anticipate with enthusiasm, not dread, because of the awesome power that will be...
How Does a Hypercharger Work on a Motorcycle?
A hypercharger is an aftermarket component on motorcycles meant to increase engine performance. It is essentially a scoop-shaped air-filter housing which serves...
What Is the Function of a Hypercharger?
Comments. You May Also Like. How to Install a Harley Hypercharger. The Kuryakyn Hypercharger is a high-flow air cleaner designed to look...
How to Remove Kuryakyn Grips
Kuryakyn's ISO grips are an attractive yet functional modification for nearly any cruiser or touring motorcycle. The grips install easily onto the...