When building the basement, the separate installation of basement floor and walls creates a small joint between the surfaces. Occasionally, as the concrete settles, the joint may widen, causing leaks or serving as an entrance for insect infestations. You can seal these joints, but you must ensure that the seal does not interfere with joint movement; otherwise, you may end up with cracks radiating outward from the newly patched area. A closed cell foam backer rod and polyurethane sealant can create the seal you desire, closing the joint while continuing to flex as the concrete moves in place.
Things You'll Need
- Wire brush
- Stiff-bristled broom
- Concrete degreaser
- Scrub brush
- Wet vacuum
- Measuring tape
- Closed cell foam backer rod
- Utility knife
- Masking tape
- Self-leveling, 1-part polyurethane sealant
Remove any dirt or debris from the joint between the floor and the wall, using a wire brush, and then sweep along the base of the wall with a stiff-bristle broom to remove any remaining loose dirt and debris. Clean the joint and about a foot of adjacent wall and floor space with a concrete degreaser, using a scrub brush to remove oil deposits. Rinse thoroughly with water, then vacuum up any moisture with a wet vacuum. Allow the concrete to dry overnight.
Measure the length and width of the joint, using a measuring tape. Cut a piece of foam backer rod slightly larger in diameter than the width of the joint to the measured length, using a utility knife. Stuff the backer rod into the joint, packing it firmly while leaving a space of about ¼ inch along the top of the rod to the surface of the floor.
Place strips of masking tape along the edges of the joint to prevent the sealer from overflowing onto the floor or wall.
Pour the self-leveling polyurethane sealant into the joint above the backer rod, filling it to the top. Start at the end of the joint and pour along the entire length, moving in a single direction. The sealant will level itself out at the top of the joint. Wait two hours for the sealer to begin to cure.
Remove the masking tape to create a clean line in the sealer at the joint edges. Allow the sealer to cure completely for seven days.
About Concrete Sealant
If you are building a basement or have a concrete garage floor, you may want to consider using a concrete sealant to...
How to Pour a Concrete Basement Floor
The floor is the last portion of the basement you will pour, after completing the footings and the concrete walls. Usually poured...
How to Seal a Basement Floor
A basement sealer prevents moisture infiltration from beneath your home that may result in excess humidity, mold and mildew. At the same...
How to Seal Basement Floor & Walls
Sealing a leaky basement not only reduces issues with flooding and mold but also gives a homeowner an opportunity to increase his...
How to Seal the Floor & Shower Wall Grout
The grout that sits between tiles is the most porous part of the wall or floor, and will allow moisture to seep...
How to Seal a Concrete Foundation
Because you have only one opportunity to seal a concrete foundation it is imperative it be completed correctly the first time. Concrete...
DIY: Stopping the Leak Between a Basement Wall & Floor
Because your basement wall is underground, it is highly susceptible to leaks. Water flooding into the soil around the basement exterior will...