Smoke alarms are designed to sound off when smoke is detected. A smoke alarm that doesn't reset itself after a power failure and instead sounds an alarm must be turned off. There are a number of procedures for turning off the smoke alarm so it is returned to its normal operational state -- none of which permanently damages the device. No special tools are needed.
Things You'll Need
- Replacement battery
- Paper towels
- Compressed air
- Cotton swab
- Distilled alcohol
Locate the "reset" button -- this can be on the smoke alarm's control panel or on the smoke alarm itself. Press and hold in the "reset" button until the alarm ceases. Release the button.
Remove the smoke alarm from the base by twisting it counterclockwise, if the alarm continues to sound unnecessarily. Remove the battery that's no longer providing enough backup power to the smoke alarm from the battery compartment. Place a fresh battery into the battery compartment. Twist the smoke alarm back onto the base.
Remove the smoke alarm from the base again, if the alarm has still not reset. Wipe out the inside of the smoke alarm and the vents on its side with a water-moistened paper towel. Dry with a paper towel. Blow off the sensor inside the smoke alarm with a burst of compressed air to remove any loose dirt or other contaminants fouling the sensor plate. Rub the sensor plate with the tip of a cotton swab moistened with distilled alcohol. Twist the smoke detector back onto the base to stop the alarm from unnecessarily sounding.
Tips & Warnings
- A smoke alarm that has had its circuitry destroyed by a power surge will need to be replaced.
How to Turn Off a Smoke Detector's Battery Alarm
Smoke detectors in your home or on your property need to be on all the time for safety reasons. But if you...
How to Stop a Hard-Wired Smoke Alarm From Chirping
A hard-wired smoke detector is one that is connected to the home's main electrical system. It may also be connected to a...
How to Reset a Home Alarm After a Power Outage
Many homeowners install alarm systems to ensure that their home is protected from intruders at all times. But if your home experiences...
Interconnected Smoke Alarm Failure With a Power Surge
Interconnected smoke alarms are hardwired and run off of the 120-volt AC electrical system in a building. Most have backup batteries to...
Do Electric Smoke Detectors Have to Be Reset?
Unlike battery-operated smoke detectors, which rely on alkaline batteries, electric smoke detectors are hardwired into your home. Though electric smoke detectors are...