How to Fix a Cracked Wooden Door

Save

Over time, hot and cold weather and moisture can cause cracks to develop in a wooden door. You may have tried filling the crack with a compound, but you probably found that this didn't work, because the crack appeared again as the wood expanded and contracted. A better solution is cleaning out the crack, applying glue and clamping the door frame until the glue has thoroughly bonded.

Things You'll Need

  • Hammer
  • Flathead screwdriver
  • 2 sawhorses or work table
  • Sandpaper, paint scraper or paint stripper
  • Pocket knife/utility knife
  • 2 wood screws
  • 2 wood clamping blocks
  • Screwdriver
  • Polyurethane glue
  • Small paintbrush
  • Clamps
  • Wood putty
  • Take the door off its hinges. Place a flathead screwdriver against the rim of the top hinge pin. Tap the screwdriver up, using a hammer, until the pin is dislodged. Repeat on all of the hinges. Place the door on a pair of sawhorses or a large work table. This will make it easier for you to do your work. Have a friend help you with the door if it is especially large or heavy.

  • Remove the paint, lacquer or varnish on the door. This will help loosen the panel where the crack is located. Use some sandpaper, a paint scraper or paint stripper to remove the paint. You can repaint or restain the door later.

  • Scrape out any paint, filler or caulk that might be inside the crack. Use a small pocket knife to get inside the crack to remove all of the debris.

  • Screw one wood clamping block on each side of the crack. Use a screwdriver or drill to screw the blocks 1/2 inch above and below the crack. Center the blocks in the middle of the crack.

  • Apply a very thin coat of polyurethane glue inside the crack. Use a small paintbrush to ensure that you get the glue into the small ends of the crack.

  • Connect a clamp around the wood clamping blocks. Tighten the clamp until the crack completely closes. Allow the glue to dry and cure for several hours or overnight.

  • Loosen and remove the clamp from the blocks. Unscrew the clamping blocks from the door. Fill in the screw holes you made with some wood putty. Allow the wood putty to dry for several hours before you apply finish.

  • Hang the door back on its hinges once the finish is dry.

Related Searches

References

  • Photo Credit Jupiterimages/Photos.com/Getty Images
Promoted By Zergnet

Comments

You May Also Like

  • How to Fix a Wood-Burning Stove

    Promptly fixing any problems with your wood-burning stove is essential for your personal safety. It also maximizes energy efficiency and minimizes air...

  • How to Fix a Refrigerator Door Seal

    Refrigerator door seals, also called gaskets, can be one of the easiest repairs available. Order the correct replacement and easily install it.

  • How to Fix Cracks and Chips in Wood Trim

    Wood trim is a beautiful accent in any home. Wood trim can be used around windows, doors, as base trim, chair rails...

  • How to Fix a Crack in a Wood Shelf

    Cracks are an unfortunate fact when dealing with wood products. Although not as common with newer furniture as the older, cracks are...

  • How to Fix a Broken Door Frame

    The door frame holds the door level. It also houses the locks that keep you and your family safe. The door jamb...

  • How to Fix Garage-Door Tension

    You want an overhead garage door to operate easily and safely, neither putting undue strain on a garage door opener (or you)...

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!