A simple and no-fuss solution, Levolor window blinds cover windows attractively to provide light control and privacy for your rooms. After installing Levolor blinds, you can further enhance a window with the addition of sheers, panels or valances to add to your room decor. Leave the blinds extended all the way down and tilt the slats open and closed or pull the blinds up to emit light through the window.
Things You'll Need
- Drill (with 1/16-inch bit)
- Phillips-head screwdriver
Determine whether you desire an outside or inside mount for the Levolor blinds. Inside mount means that the blinds sit inside the window trim, snugly against the window glass. Outside mount means that the blinds sit against the outside of the window trim. Use an outside mount to cover more window trim and an inside mount to allow more window trim to show.
Install the brackets to hold the blinds in place. The two brackets go in the upper right and left corners to hold the blinds. If you opt for an outside mount, install the brackets to the top edge of the window trim with two screws going into the side edge of the brackets. If you opt for an inside mount, install the brackets to the inside edge of the window trim with two screws going into the upper edge of the brackets. Drill pilot holes with the drill and then install the brackets with screws and the screwdriver.
Insert the end caps into the top and bottom edges of the blinds.
Snap the headrail at the top of the blinds into the brackets by aligning the bottom edge of the headrail and pushing the top edge into the brackets until it clicks into place.
Hook the slat wand into place at the upper left edge of the blinds. Open and close the blind slats by twisting the wand.
Install hold-down brackets at the bottom right and left corners of the windows if you desire. The hold-down brackets screw into place at the bottom corners of the window and then snap onto the end caps on the bottom edge of the blinds.
Tips & Warnings
- If you plan to leave the blinds in the completely extended position and use only the wand to open and close the slats, you might like using these hold-down brackets to hold the blinds securely in place at the window. If you plan to raise and lower the blinds with the cords, you probably don't need to use the hold-down brackets.
- Make your blinds child-safe by using cord-stops. Lower the blinds to the lowest position you will want to use them and check the cord-stops to ensure they are in the correct position. The cord-stops need to be between 1 and 2 inches below the headrail to prevent strangulation. If the cord-stops are too low, loosen the knots around the cord-stops and move the cord-stops up to within 1 to 2 inches below the headrail. Tighten the knots around the cord-stops again.
- Photo Credit Jupiterimages/Comstock/Getty Images
How to Mount Blinds on the Outside of a Window
Blinds can be mounted on the outside of a window by first measuring the window and determining the proper placement. Mount blinds...
How to Make Fish Tacos
Shred cabbage. Prepare the sauce by combining plain yogurt, mayonnaise, cilantro, jalapenos and onions in a bowl. Add salt and pepper to...
How to Install Top Mount Window Blinds
Window blinds are an economical and quick solution for window coverings. Top mount blinds are supported by brackets that install behind the...